Oh dear, sounds like you have had some issues Steve. OK, As I said previously, I have no experience with the KM145's exept for the transmission end of...
Hey guys, well yesterday I finally got my MSD 6A ignition from summitracing. At first I was prepared with extacly what do to, I found a good spot for the unit...
I will either part this out or sell it all for 250 dollars. The tail gate is excellent as are the doors and all glass. The bed is almost perfect and no rust...
Is this the 4X2 or 4X4 model? Where are you located? ... From: justmenmyson To: dodgeram50truckowners@yahoogroups.com Sent: Wednesday, May 04, 2005 12:25 AM ...
I have been wanting to reply to this post for a while, but I have been on vacation for the last week and a bit, so I have had limited internet access. I fitted...
I am San Jose and the rear window is a slider so I think its 4 piece.. I will sell the door panels separately for 50 dollars a pair, The truck is a dark...
If it's the factory slider window, it will have one center panel, ie. 3 pc. Does the $50.00 include shipping? What type of door mirrors, and how much? ... ...
The rear slider window has 4 separate pieces of glass, The mirrors are factory stock, nothing special 20 dollars for the pair and no shipping is included for...
not a problem, not like these things are growing on trees though.... Not really worth my time to part this truck out as everyone wants something for nothing...
Hey guys! I got my truck back together after it blew the head gasket. It's running pretty good except for a few things. I've got what I think is a vacuum leak....
Do you have a Haynes Manual, or Chilton's, of a FSM? You should have a diagram under the hood that shows where the lines go, the manual will tell you what...
Are you any closer yet Steve? I spoke to a friend here in Austrlia, that is familiar with the KM145, and he agreed with Fred, Yes you need to knock that pin...
Hi, I'm sorry for use this topic. Just a question related to the T case. Is it normal that the stick of the transfer case get some heat over an hour of drive? ...
I do have both the Haynes and a FSM. sounds like I should take the diagram, the manual, my air cleaner, and a blank piece of paper and try to draw out a plan...
- well i haven't messed with it,but this wknd. i plan to go at it again,i can see where the shift cup might be in the way, i only hope thats all. chiltons says...
First of all thanks for the response Jamie. I think if I ordering hr12 from AU might be a little expensive, I did find what I think is the same product from...
The T-case stick will get warm, it's right beside the exhaust, and the oil itself will heat up. I also use the same gear oil as I use in the diffs. GL4 or GL5,...
Steve, If I'm reading this right, the shifter cup cannot be removed independantly. The only way to get the cup off the shaft, is to first remove the pin, then...
Oil? I don't know what you mean. The complete A/C system was completely vacuumed and then recharged with HR12, no oil was put into the system. Jamie...
... Hi fred,no,what i meant to say is chiltons says the transfer case can be removed independently and haynes says you have to remove the transmission first....
There is usually oil in the system for the compressor. I did some more research, I found a reference that the system uses 6.76 ounces of oil, did not have a...
... Well i finally got the transfer case out. I found small broken parts in the transmission extension,a mangled synchro spring and a pin of unknown origin. I...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
