Hi Stuart, to start with that manifold is rated from 1500 rpm up. that leaves a little gap for a dead spot from your idle speed to the min rpm for the...
At idle its at a pretty steady 15-16, at full throttle its at about 20-21. From my understanding the vacuum reading should be higher when the throttle is...
i own a 1970 dodge dart custom that has been sitting around for a few months, and i just recently began getting it ready for the road. i went to remove the...
I can't think of the name of the product but all automotive stores carry it. It's used to loosen nuts that are locked/rusted/etc. Try spraying some of that...
I think you are talking about PB Blaster. It's in a white can with lots of black and some red. Really good stuff, smells like crap but it works. I used it on...
It is called "Liquid Wrench" and it works great. Pat nowhereman916 <efface@...> wrote: I can't think of the name of the product but all automotive stores...
thanks guys, i'll give it a shot -- Derek Wohlust Production Technician/ Database Manager Phillips Center for the Performing Arts University Of Florida ...
I have had a few seized oil filters through the years that were on there so tight that I had to chisel them off. It's not a bad as it sounds, you just get a...
How about one of those "sockets" that with the bottom edge of the oil filter, Then you can attack a breaker bar to it. dwohlust <dwohlust@...> wrote: i own...
I just refinanced my home loan at better interest rate; this saved me thousands of dollars and will repair my horrible credit. All the information is right...
Hey I just wanted to tell you about a great company I found! I applyed for a lower mortgage rate and i only had to fill in a simple form. This month alone I...
Bored? Want to meet someone new? Chat with Real Women in YOUR AREA 1-800-335-9396 Only $0.99 min with a major credit card. NO CONNECT FEES! No credit card? No...
hello folks. Anyone possibly intrested in a Dodge Dart that I have for sale, let me know. She's in good condition. Looking 10grand or best offer for it. 1971...
I have a 1973 Dart 4 door with a 225 1 barrel slant six and a three speed automatic transmission. it does not have any dents and very very little rust all it...
in reference to your slant 6 Dart. My Dodge orginally had a 225 in it. single brl. And if I remember right, my 0-60 time with my 71, was a 0-60 of 5.9 seconds....
... it. ... a 0-60 of 5.9 ... gear for the ... Stock ... seconds judging by ... machine tests your ... through the highest ... down force ... Yes I am...
then you should have 5.9 on the 0-60 meter. but like I said check it on a Dyno test for sure. _Logan [Non-text portions of this message have been removed]...
My BS meter is pegging on this one. I believe 5 second range with the built 318, barely. You're tranny isn't up to that power and will probably be an issue...
Well I`m not gonna sit here and spill lies to anyone. especially when I don't have anything to proove, and I'm not going to be part of some romper room ...
I drove this car to high school in the early 90's and it has been parked since June of 1992 when I enlisted in the Marine Corps. The car has been kept under a...
I think there are two more typo's here. You should have typed 10.6 seconds (you may be right but I've had 15 or 20 slant six one and two barrels in 2 and 4...
A couple of months ago when I bought a set of 5.9L edelbrock aluminum heads from jegs I also bought a head stud kit to ensure a good strong top end. Today in...
Hey Arnold, it seems to me that if you ordered them both at the same time for the same engine it should be on jegs to cover the freight on the new kit. it...
just introducing myself. i own a 1970 dodge dart swinger that i am starting to restore. she has a 198 /6 with a 3 speed on the column, 33k miles and is all...
Anyone live near Danville/Montour PA? There's a Valiant there I might be interested in and I would like someone to look at it for me and report back (possibly...