... Here in Iowa, the hardest part of getting my title was getting the DOT inspector on the phone. Once I talked to him, he drove to my home (60 miles) looked...
Greetings - Some 6v electrical parts I'm trying to hunt down for my k-750 (and their original part Numbers). Any help would be appreciated. -Complete set of 6v...
I have some 6 volt bulbs on the website. You might see it they fit anything on your bike. The definatlt fit things stuff on the M-72. I will rummage around and...
What is the proper wt.of oil to be used in the DNEPR MT-11 engine? rear end? The person I purchased it from told me 30 wt. Could this be correct? Anxious. Old...
OIL THREAD ALERT! OIL THREAD ALERT! James, check the past posts about oil. You will find there are many differing opinions on the subject. Generally...
It may be a good week for anyone interested in a Dnepr do it yourself project. There appears to be an MB 650 (listed as an MT-16) and an old Neval on ebay....
In a message dated 6/2/2006 9:25:18 AM Romance Daylight Time, dneprheads@yahoogroups.com writes: What is the proper wt.of oil to be used in the DNEPR MT-11...
Just a reminder that the first commie bike gathering will be held at the Blast From the Past diner in Waterboro, Maine, at 1:00 on Saturday, June 17. Everyone...
Hello Dnepr Heads, I am having a problem with my MT-16 650 cc. I shorted out the kill switch under the seat with the metal seat bracket. The whole bike went...
I use 20-50 to break in an engine, changing at about 500 Km, Then go straight to Mobil 1, It is the best of the lubes I see out there that is commonly ...
My switch merely interrupts the connection to ground for the battery, thus preventing any long term drain. I would thinks yours is the same. "Shorting" it...
Hey Kalab, Check your points in the ignition points assembly housing. I experienced a similar problem recently, and much to my surprise my points were fried. ...
Here is some blatant commercial speech. Please delete now if you don't want to read about a new section in my web site. I have finally completed (almost...
Hello, Would anyone have a good right head for a MT-11 they would sell? My bike is dead until I get one. I had found a used one, then a new one for a few $...
If you could put together some kits and prices for MT16s etc. Some of us would probably like to replace everything as we work on the bikes. thank you in...
Hello, I pulled the head, and took it apart, and found one compleatly worn out valve guide. Anyone know where I can get one? That will get me back on the road,...
... I have to admit that I am a little hesitant to do so. It takes 3 things to do kits correctly. 1. An accurate parts catalog for each year of the model....
Hello Dnepr Heads, Thanks for all your help with my electrical problem. I checked the coil, and I am getting 10.4 volts on the terminal that is on the sidecar...
Andy I am trying to list all the fasteners by size right onto the exploded diagrams as I re-do the diagrams on my site. I didn't start it that way, but I try...
That would be excellent. The guys could download the drawings to figure out what they need. They could then get fasteners wherever they wanted to. Of course,...
With the points open you should see 12 volts from vehicle frame to positive terminal of coil with every switch in run position. At the same time, you should...
You actually have a Dinamit? rob20001955mg@... wrote: Greetings Dnepr Heads, Any chance of finding NEW parts for this rare 998cc engine? Has anyone ever...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
