Hi everyone, recently I found out I may need to do some engine work/rebuilding on my car. I'm having a compresion problem and was told that there maybe...
List: I'm in the process of aligning my striker pins so the doors close easier without as much "clunking". So far I have adjusted the drivers side well, I can...
Stock DeLorean Wheel Offset, Dimensions, and Weight. I recently had my DeLorean's wheels stripped and powder coated and I figured that while they were off the...
You may also have to adjust the pins fore and aft. Some times the pins are adjusted too far forward and actually are hitting the door or are too far rearward...
Joe From one of our DOC UK committee members :)... i would ask for his advice but he is away at the mo.. they are def NOS ones thou:) Regards Mike #2001 /UK ...
Ben Looks like you really did your homework! When we wrote our story on custom wheels in Vol 2 Issue 1, we did a lot of research on wheel sizes that would...
There are two styles of OEM shocks, some with wide bushings and some with narrow. I bought a set from DMCH a Long time ago (maybe 1998?) and they supplied some...
I am going to replace my front calipers, shoes and shims next week, and install stainless brake lines. My front brake right now squeal very loudly at the...
I have a similar issue with my doors not being able to align properly. With my passenger door, the actual door makes contact with the fiberglass body. I can...
I'm no expert, but it sounds like you need more drastic alignment work. This sounds like you need to actually loosen and move the door into correct position....
Thanks to some helpful advice & digital pics from fellow dmcnewsers, I was able to solve my captive nut conundrum. After wasting my time trying to retrieve it...
With a Pressure bleeder I bleed the whole car in 20 minutes. Very easy. You have to jack up and remove the rear wheels to bleed the rear caliper but the...
Well, from what I understand, my car overheated quite drastically and also seized (if I'm remembering right, anyway). The POs dropped in a new PRV6, and it's...
My car has exhaust leaks that are becoming very evident by my ear. The driver side exahaust manifold looks like the gasket was recently replaced. The nuts and...
Stick with the PRV! They are good engines once set up right. And by keeping it original the value should stay good, and getting help and advice from this forum...
I can hear a high pitch ticking noise, which sounds like a sewing machine, in the passenger side valve train. My mechanic doesnt know if it is hydrolic or...
I would bet money that it's an exhaust leak at the manifold. More often than not, someone not familiar with the car makes this mistake. Dave Swingle ... if...
I agree with Thomas, Darryl. If you don't have much mechanical ability, an engine swap wouldn't be a good idea. The reason I say so is because the labor...
The service manual talks about removing the lateral restraint bracket under the RH support bushing. I can't find a picture of this bracket in the parts manual....
http://www.chron.com/cs/CDA/ssistory.mpl/ae/art/3238789 "Houston-based sculptor Katrina Moorhead is one of 14 artists representing Northern Ireland in this...
Like Dave said, But are you running the 20/40 oil. John Hervey ... From: dmcnews@yahoogroups.com [mailto:dmcnews@yahoogroups.com]On Behalf Of stefandmc Sent:...
