Randy, I epoxied mine about 2 years ago. It is still holding strong. The key is to use a thin metal sleeve inside the plastic pieces to be epoxied. I believe...
They seem to be in good shape but I will look closer. Sure seems like the solenoid is stuck. I tried tapping it with a sharp thump but it did not make any...
Hi Randy. I too had under one inch left to fasten the upper hose to but pushing the clamp all the way to the radiator has lasted over two years. Still have...
Before you pull the starter, try 2 additional things. Put the car in neutral then try to start it; sometimes the transmission lockout switches on these cars go...
anyone have a link to this? or can point me in correct direction? & what kind of expoxys? hope not jb weld.. there are so many better expoxies thank you, Randy...
In a message dated 7/1/2006 5:26:27 AM Pacific Daylight Time, ssgkag@... writes: Hi Randy. I too had under one inch left to fasten the upper hose to...
I hear you, I am faced with a similar dilemma. Band-aid fix the radiator or bite the bullet and get a new one. It is going to cost C$300+taxes for a new...
start with a 24 inch extension, (keep more shorter extensions readily available) then a u-joint, then a 3 inch extension, (this has been known to help but may...
Its located about 80 miles south of Miami Florida, I haven't seen the Doc lately so I don't know what price he would be asking. I'm thinking from what I saw on...
Thanks to all for your thoughts and suggestions ... I got the starter out ... holding your mouth just right helps :) Took the solenoid apart by removing the 3...
bummed out this is from mercedessource PLEASE NOTE This kit is meant for preventative measures only! If your radiator neck has already broken, you cannot use...
Just bought a 1976 300D that will not start. While I am not new to diesel engines, this is my first Mercedes so bare with me. I do not know the history of...
Mac, Solenoid not moving is either the coil is bad or the motion is mechanically sticking. You tested the coil - 4 ohms - and you got a small spark when you ...
Dan, Let me think about rebuilding your transmission. I have so many of my own "projects" that I have been turning away work, but, none of that other work was...
In a message dated 7/1/2006 10:17:45 PM Pacific Daylight Time, davidheistuman@... writes: The glow plug light does not illuminate but I checked and do...
For those looking for this - the discussion and photo is most of the way down this page: http://www.mercedessource.com/alerts.html#sga The preventative kit is...
Tom, My 79 300CD has series plugs, so I'm sure his originally did. (There is some chance his car has been switched to parallel.) I jury rigged a meter to the...
... neutral when your up to about 45 put in drive & hit the key once the engine turns over from the starter then the tranny will take over. (Disconect the...
... a small camcorder that has sound I also have a tripod so You could just set it & work. If it turns good enough You could get rich selling the tape right...
... Actually, you don't need to operate the starter at all to push-start a Benz. Turn the key to the "on" position, push it to above 30 MPH or so, and drop it...
Yeah, push starting is much safer than pull starting. And you won't need to disconnect the neutral safety switch or operate the starter. These old Benz's had a...
ok i looked at pic.. way worse than mine. i still have a partial neck that whole neck broke off i have i guess 1 inch maybe a little more to clamp to & it was...
Are you following the proper starting procedure?? Glow for 10-30 seconds (temperature dependant, more when cold) Foot feed right on the floor, then crank until...
In a message dated 7/1/2006 11:37:33 PM Pacific Daylight Time, ... some >>chance his car has been switched to parallel.) ... to being >>a direct short that...
As for me, all I'd need is a proper manual. Where would one get a transmission manual for the Merc?? Thanks Jeff Dan, Let me think about rebuilding your...
