Hi,,,I am new here,,,,and I too would like to know if,,,,when installing new valves can they be lapped?,,,also,,,am installing new timing chain in my...
You are correct for the timing chain; TDC and closed valves. The circle on the cam sprocket aligns to the mark in the head (towards the front of the motor or...
-Thanks for the reply on my valve guide question. It sounds as though it's not as simple as just a quick "lap and seal". Eric ... new ... a ... coating" ... ...
In the past, I was wondering about interchangability of K0-K1 exhaust systems. It is true that they are not the same. I know for sure that a K0 exhaust will...
I dont know about the coating on ct90 valves but many cars and trucks have a stellite coating on the valves which helps to protect them from the heat. I have a...
Hi All - does anybody have any advice for using this product CD2 for 'sealing worn rings'. i got some advive to try it, but am not usually a fan of these...
_WELCOME_ ! . Clean the engine off completely , using a tooth brush as needed and let it dry then fire it up and lay on your side and watch it to see _exactly_...
Yes , simple after you've done it once or twice . Pretty much ALL Hondas use .002" clearance on both valves , set the engine to the " T " mark (TDC) and do it...
Aren't the early models having a smaller intake port ? . It seems to me the models with the forward facing carby have a smaller intake port . (?) -Nate...
It's snake oil and I'd not be putting it into _my_ engine . It is almost impossible to re-seat old piston rings and it is _IMPOSSIBLE_ for " worn out " piston...
Hi, I am looking for the following parts for a 1978 CT90 'Postie' bike - I hope someone can help... ... I am located in Perth, Western Australia but will look...
Meet passionate bikers to share their happy. Meet tens of thousands of passional single bikers to share their personal areas and enthusiasm. Membership is open...
Thanks Nate, This bike has been a fun project. The engine came off Ebay so I just want to try the valve adjust to see if it may smooth out some. I'am sure...
Hey, Good advice Nate. I've looked for things for long periods of time, just because I couldn't see them against neutral contrasts, like black and brown. Your...
Hey yall, I've been wondering, when looking for a good air compressor that can do pretty much everything, what kind of p.s.i's and cfm's are you looking for?...
Hey again, On the photos site, gracefully made by mwaynebennet, I posted a rare split in half cm91, brother of the ct90. Does anybody know anything about...
tools are dangerous....I have somewhere around $10,000 to $15,000 in tools at the moment....granted they are handy. I used to work as auto tech, not now...
Some other mailing lists I am on periodically (like every couple of months) send out a message that everyone who want to stay on the list replies to. Anyone...
Mark, I kind of have a funny feeling 'cause you just left your answer simple. I remember that you said you know a lot about these exhaust systems (believe me,...
Ryan: I think that a solution would be to use the exhaust pipe/header pipe from a K1-> up exhaust system and weld it to a K0 muffler. Where the weld is, there ...
Hey, I restored that tank, nice paint eh? I polished and waxed it untill it blinded me, no just joking, I didn't. I posted that picture, but I have no idea who...
Should be a straight swap. TF ... From: ambaddley To: ct90@yahoogroups.com Sent: Sunday, November 02, 2003 3:52 PM Subject: [CT90] I have a question I was...
There is some info in the listings that deal with it. It is under my understanding that you can- but pay attention to the electrical differences. That is,...
