it turns out that the neutral light was on because it was stuck in neutral. i got the engine running well enough to try out riding it around the yard and...
I ran across these tachs and had to buy 2. When I first put one on I thought it was much slower update than my SenDac. Now I am sure it is about the same -- 1...
Brad, that screw usually gets ground down when it comes loose and rubs against the back of the main drive gear. The only requirement to replace it is that it...
Hello Bob, I was digging around on CT 90 web site and found your recommendation for upgrades to LED lighting. If you have a minute, I have questions: 1 - The...
I would call super brite for the brake tail light you need the bulb with 2 brightness they call them dual filement or something like that for the turn signals...
I recently aquired a 2001 Honda TRX450ES 4x4 Quad for use on my new 5 acre property. I was wondering where might be a good sorce parts. Mainly I need a carb...
Rick More info the brake tail light from super bright is 1157 (BAY 15D) in Red it is a dual contact dual intensity bulb I bought it in red one post on the bulb...
      Gary  The Honda stealers Aka.Dealers would still have those body parts  and other Honda design only clips on the books I assume.as for the carb...
Good Morning Group, Thanks to DRAVT, Ebay and information provided by the group, I am nearing completion of the restoration of my bike. Hopefully today I...
I would use a dealer for new parts like that. Dealers need the business and we need them. I buy from Beatrice for my ct because of his great contributions to...
Dan, the early model CB's have the setup you need. The turn signals have a "foot" on the end of the stem that is made for a mount exactly like the front...
Hi Guys/Gals, on the late model CT90s and all CT110s, is the choke engaged when the lever is in the up (horz) position or in the down (semi-vert) position?...
Hi again, I'm having trouble locating a part for my new 1979 CT90. A previous owner dropped the bike and broke off the right side rear mirror mount from the...
I was setting the ignition timing on my CT90-K6 and used my multi-tester's ohm meter to see if the points were opening at the correct time. They did but I had...
About 2 years ago I bought the last two early model K1 isolaters available from CMSNL.com. Because they were so rare I wanted them in stock in case I ever...
Mike, Yep, it is grounded at the coil. The only way to check for continuity loss is to unplug the points wire. Think of it like a light bulb - if you check the...
Anyone out there own one of the old Hondomatic big bike if so how are they on the interstate at say 65 to 70 are they just 2 speed. Your thoughts appreciated ...
I am thinking about installing a remote oil cooler. Does any one know the location for engine case taps? Or an web link? I have a stock 69 Honda CT90. ...
This may not be advisable for several reasons. One, the oil pump probably does not have the capacity to do it and two, oil needs to get up to a certain...
     Eric  You would be best to find a conversion kit that all the parts needed if there is one. If not you will do a little fabrication work on the...
Yes Roy, I believe it was you. If you still need it and will install it right away and ride your bike, send me your address and I'll mail it to you. Then after...
owned 1 years ago ran pretty good out on interstate has low & drive the yahoo honda 750 group has a few members with them maybe you could ask there for more...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
