To all: I believe that PPG no longer provides DDL. In most states it does not meet VOC requirements. It has been replaced with Deltron DBU BC/CC Urethane....
Allan: As of one year ago I was still able to purchase PPG lacquer from my automotive paint store. I know there are some states, and some areas in some...
i need some help with a my 71 vega, i'm loking for a hydrolic clutch system for it but i cant find one i was wondering if any one can help me to find one or...
I think the best way to do this in a Vega is to adapt a hydraulic throwout bearing from another production car with one (Jeep) and install a master cylinder...
Mark: I understand your concerns, but Acrylic lacquer, is over 30 years old. I was just bringing it to light that it was going away. Spending the time...
Allen, If i might jump in here... Try to turn the engine over by hand using a 1/2" drive ratchet and a socket that fits on the bolt in the front of the...
Does anyone have a larger Vega/Cosworth A/C radiator fan blade for sale? That is the only piece I need to complete the changeover to a completely NOS AC...
Allan: There are many choices available to those who want to refinish their Cosworth. I've seen Imron, BC/CC, Enamel, lacquer, and probably others. It is...
Well as of 4:45 today. after a long labor of love. Cosworthvega #2835 is now back in the land of the running cosworths again. Many thanks to all the clubmember...
I had to replace a bad tps on #2835. What degre or # should line up with the mark on the intake? Also is there a extra spring or somthing to pull the accel...
Jon: There is no "set" mark for lining up the TPS. Each installation is a little bit different. The marks are for reference in the event you need to remove...
Where can I find a set of decent sparkplug wires. I was only able to find one place local that says that they can get a set of wires for a cosworth. I willing...
Jon Running on only one or two cylinders is a not uncommon problem. It is not a plug wire problem. Nor is it an ignition module problem, as those usually fail...
Hi, group spark pulg wires can be made up. just use your old groumets and spark plug boots. the boot end that fits over the distributor cap can be purchased...
Does anyone have a Cosworth dash bezel insert with the gold paint faded or stripped (but in otherwise great shape) that you would be willing to sell? Please...
I have a extra set of cam sprokets for sale. These HAVNOT been reindexed. Price for the set are 50$ plus shippage from Utah. Email me at vegalover@... if...
I understand your frustration.. I played around trying to get mine to run on 4 cylinders so long and tried so many different variables, I was ready to smash it...
Ok one more thought change the coil and coil wire too. only $15 at a parts store.. that could be your culprit.. also check the wires onthe back of the...
First off thanks to people who have responed with help on this problem. I went to a salvage yard grabbed 4 wires off a toyota 1600 duel cam engine and 2 S10...
Jon, I thought I'd chip in even though there are more on here more conversant with the CV than I am. All the pointers already given to you are relatively easy...
Guys: I have left the car with mystery oil in thy cylinders for two weeks and the problem is still the same. I have only tried to turn the engine over (no...
Help: I have two 4 ohm speakers and want the radio to see an 8 ohm load. Do I connect them in series or in parallel? No, I don't have any resistors, though I...
Gary, Jim I connected them in series and they work fine. Thanks. The previous owner of this Cosworth put two 4 ohm Polk speakers in the underdash panel. The...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
