Hey all! The board has been really quiet but I'll put this out... 95 XJ witha about 196K on it. Runs really good..when it starts. When it's sat for a while...
My XJ already has a 3" suspension lift with new coils and leafs. I just recently put 31" tires on it and there is a little bit of rubbing. I know that there...
Bryan, have you just considered trimming off the offending area that might be rubbing under full compression or when turning? It's better to keep the COG lower...
If you don't already have a 'puck' spacer on the coils and a longer leaf spring shackle, that's all that you'll need. A 1" coil spring spacer, and a 1" lift...
Thanks guys, Its a 97' and I am going to be doing some trimming but I don't really see that doing much accept letting me drive around town without any rubbing....
I have heard rumors that the rubicon t-case is an easy swap for the 231 and is about the same cost as buying a 4:1 kit and sye. I have a 96 xj with a 5spd is...
Don't just let them dangle. Remount them to the frame. YJ hoses are said to work well also. Ron ... straighten the metal line. Should give you a extra 3" or...
I have one in my 90 using a 98 tranny. I'd guess the length of the output on the 96 is the same as the 98, but you need to be sure. I've been less than...
Advanced and autozone have quite a few different generic fit ones that look and work good but if you want prefessional look and feel try Katz skin seat covers...
The kid's XJ has a broken center section of the double cardon in the front drive shaft. Anybody replace a front shaft and have the stock shaft laying around...
Found this posted in another forum : After searching for `Camp Jeep 2008' on Yahoo and finding this post, I called Jeep at 877-CAMP-JEEP to see if they'd talk...
I found a passenger side one at a wrecking yard called the bone yard on 53rd & Monroe in Denver, $35, they also have the drivers side if you want it....
I was wondering if anyone has a serpentine pully that resides in place of the XJ's Sanden A/C Compressor - which sits in place of the pump when it is a non-A/C...
I remember reading about a shop in Cheyenne that does a good job setting XJs up for off roading. I need some front end work done ie: new coils ,upper & lower...
These guys? http://www.tntcustoms.com/webV5/default2.asp Chris To: colorado-xj@yahoogroups.com From: xjnco@... Date: Sat, 5 Jan 2008 12:38:12 +0000 ...
That would be TNT customs, about the best parts and installs anywhere Hours of Operation: M-F 8am to 5pm MDT Phone: 307.775.9565 Shop Address: 216 Ave. D....
Hey four posts in one day with two correct answers doesn't seem dead to me. You, on the other hand.... Fred ... From: Mike Ginter<mailto:mikeginter@...> ...
I really like their tube fenders for tj's...seem to have a pretty good axle truss setup for d30's as well if I remember correctly. I talked to one of the guys...
I met a few people running there long arm set up for the xj and where really happy, but I've heard some bad things about there other products and that when you...
Cool deal Mike - some of us old geezers need to get in touch this summer for a little wheeling. Aaron Aaron Storms, Publisher Gilpin County News PO Box 93 ...
That's a good idea, Aaron! I wish my 'rig' was ready- this $200 xj I've been driving the last couple years just needs an engine, clutch, trans and lift. It...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
