Ron Its is called a Quick-Lok and it is distirbuted by Genuine Gear and after a lot of tech calls i have determined that it is made by track tec. It looks...
Yeah, you just told me the same thing i have heard from a couple other people with the same problem. That is also what we determined the problem to be, the...
Occassionly, when my 2001 XJ's engine is hot, restarting will result in it stumbling/idling rough until it is rev'd a few times. If, however, I rev it...
I have had a similar problem with mine, only does it once in a while, when it is warm (not overheating) and once on a while when i am idling in first low range...
I first thought 02 censors but maybe clogged injectors. I would throw a can of bg22k in there and see if you have any change. It is worth a try at only 22...
Long shot - but it could be a intermittent issue with your fuel pump not providing adequate pressure to the injectors. My much older 92 was having similar...
Check the throttle body for buildup around the plate and idle air control. Also, has it had the heat shild installed under the injectors. It was a recall...
Hey guys, New/Old to this list. Used to have an 88 cherokee. Worked for Rock Ware. Some of you may remember me. Anyway, Sometimes my 87 4.0 dies. When I...
Usually a high idle is caused by gunk build up in the throttle body causing the idle air bypass gizmo to stick open. It works best to pull the throttle body...
[Carl Ellis] Yeah thanks, I figured as much. I just wasn't sure were the IAC was. I also have a vacuum diaphram on the side of the intake manifold. It has a...
Hi Carl, that used to happen to my 87xj occasionally, especially after an engine wash at the car wash where I got water on the TPS. I had to end up replacing...
Hey also..... DO I need any gaskets to pull the TB? I would hate to get it off and find out I need something to reinsatll. [Carl Ellis] Yeah thanks, I figured...
Hey all, I am in a pickle and need to borrow a flatbed for a few days to go retrieve a vehicle that I sold someone and they didn't finish paying me for. He ran...
1991 Cherokee Laredo, I would like to sell the whole thing rather than part it out. So it's cheap. It had an electrical fire in the engine compartment, so...
[Carl Ellis] Ok, so I pulled the IAC (Idle Air Control?) and cleaned it. Now my XJ Idles much smoother (MUCH Smoother) with little or no miss. However, it...
I think some of the models had adjustments available, but the one I replaced on my 87xj was a 5-minute swap with excellent results after cleaning the engine a...
I'm not sur why it didn't post last nights, but... I think this thread from the NAXJA forum could be of some assistance to early renix equipped Jeep owners....
I've got a friend that needs a new rear diff for his cherokee. It has the Chrysler rear diff. If you have a complete assembly for sale, please call me at my...
Hey Jeff! Not sure if you checked your neighbor over there, but i know that Charlie from Jeeperformance has at least 2 donor xj's that he uses for parts. Just...
I called Charlie on another issue but he did mention that he has a Chrysler 8.25 he could part with. If you have not met him, he is a great guy to deal with....
Wow, that took awhile, but was good info - thanks for the link Ron. Quick summary - clean all your engine grounds, especially the two from the firewall. One is...
Hello everyone, I am in need of some wagoneer axles for my XJ, I need the drivers side drop, and I also was wondering if anybody had any sliders that they want...
I have an '84 Grand Wagoneer that still has the axles, the rear is an AMC20 (one piece axle shafts) and the front is a Dana 44. The front I believe has the...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
