I tried to find a magnetic drain plug for the oil pan and tranny today. No luck. Autozone didn't have one to fit. Anyone have part numbers? Thanks, Todd...
Hi Todd, I made my own. A trip to the local hardware store where I found some small bar magnets about 1/4 X 1/4 X 3/4. Then I drilled a hole in the center of...
Can't help you with a parts number, but NAPA was able to order for me and I had it next day. $3-$4 bucks if I remember. They'll match threads at the store ...
Note: forwarded message attached. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
Note: forwarded message attached. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
Note: forwarded message attached. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
Note: forwarded message attached. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
I got an e-mail notification of post #304, and the ones following, and it was a redirect to a bunch of crap. Then there are these "unable to deliver message"...
I have got spates of "unable to deliver" messages recently that are indeed detected by my system as a virus. However the virus is in someone else's computer...
I'm getting that crap in ALL of my yahoo groups. I haven't opened a single file, so I certainly shouldn't have a virus. But, some of this stuff is spoofing my ...
Thanks for the replies. It looks to me like it started here with post 304. I'll run a thorough virus scan again to be sure. So far, this is the only group that...
Hi everybody, New e-mail address for Phil Smith (Dr Disk) Apologies about not having sent out a Christmas letter this year; with big moves in the pipeline, I...
Hi WhenI tune individual cylinders, right hand cyl wont rev clean. If I close the choke almost completely, then tune cylinder, it will rev out better, but...
Check the fuel flow from the tank to the carb. Sounds like too little fuel or you have an air leak somewhere between the choke and cylinder. If you are real...
Peter, The same situation happend to me when I was using the plastic gas filters on my Chang. With the filter placement being close to the engine, it melted...
Thanks for the replys. Tried the spray bottle of fuel around intake and carb, but no change in idle. I have spare carbs changed them and still runs breathless...
valve clearance OK,going to shorten fuel line so its pointing down, maybe better flow?Interesting ,when i use retard lever on left cyl,it has noticable effect,...
No it's not normal. Mine effects both cylinders. Is your bike a M1 22hp 6v? How is your compression? If they check OK, then I would replace the condensor,...
my OHV engine has developed a serious oil leak, about a quart every hundred miles. It seems to be coming from up high and from under the front engine cover. it...
Just bought a used M1M, and I'm in need of some spokes for the wheels. Does anyone know where I might buy short and long spokes at a good price. I did find...
I'm in need of some spokes for my M1M. I've found some stainless steel, U.S. made ones, but at $110 per set, they are out of my price range. Anyone know...
Greetings Mr. Shooting, Not long ago John Heim (Chang Jiang US) one of Dan's sponsors was advertising spoke sets that featured correct inside and outside...
Hey there everybody, I have an OHV charging question or two I'd like to run by the group. I searched first for any past posts on the OHV alternator and...
Thanks for input. I raised needle on lean side and it helps even things out, also havnt had time to look at timing but still starts easy. Due to lack of use Im...
This is my first time asking any questions.......Thank you I have a M1M 12 volt w/ side car and after the long winter here in Michigan The clutch seems to be...
Hi, DIsconnect the clutch cable and see if the clutch is still engaged. If yes then you need to check if the clutch actuating parts are not stuck and pevent...
Meet biker babes and biker dudes in your area and keep in touch with them in our community. Our social net-work service includes blog, forums, web mail,...
Meet hot biker babes and biker dudes here and keep in touch with them in our community. Our social net-work service includes blog, forums, web mail, groups,...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
