Several things to sort through here. Real quick... Hard starting -- Possible causes: choke misadjustment, base jetting / mix misadjustment, incorrect starting...
Michael Shimniok
mes@...
Jun 1, 2009 4:27 pm
74500
Same is true for oil pump AFAIK....
Michael Shimniok
mes@...
Jun 1, 2009 4:28 pm
74501
Oh, I wondered what I did to mess up the temp gauge when I replaced my stock bbl manifold with an older AMC 4bbl.....I believe I used the sending unit that was...
-I have some parts for sale. I have a 360 V8 out of a 90 GW has around 120k on it.. w/ motocraft 2bbl It runs solid, just change some seals. 100$ -Tf-727...
I am interested in the motor. Jason Sent from my iPhone On Jun 1, 2009, at 11:37, Pat Morzyszek <morzyszek@...> wrote: -I have some parts for sale. I...
let me know, like i said i am in Vail, i have hoist. To: cfsja@yahoogroups.com From: brutus_1974_j10@... Date: Mon, 1 Jun 2009 13:55:35 -0700 Subject:...
What are the seals it needs, Jason Sent from my iPhone On Jun 1, 2009, at 15:07, Pat Morzyszek <morzyszek@...> wrote: let me know, like i said i am in...
well it leaked some oil, i'd say oil pan .. perhaps main.. To: cfsja@yahoogroups.com From: brutus_1974_j10@... Date: Mon, 1 Jun 2009 14:09:40 -0700 ...
I got "Amy" up and running tonight. I replaced the coil and solenoid, put a new battery in her, and did a complete oil change and put in new spark plugs. I...
Fred, I am not having any luck on getting someone to pick it up for me and I know it will not be until Sept. before I could get it. So let someone else have...
You bet it will. You just can't diagnose a transmission when the motor won't run. Congrats! I can hear the excitement in you voice...:) Sorry I'm not...
The choke pull-off is on the passenger-side rear of the carb. It's a vacuum solenoid that when cold, cracks open the choke plate enough for the engine to...
The temp sending unit is a variable resistor. As it warms it loses resistance within a specified range indicating the temperature. As everyone has said, you...
Unless your kids think you're mean and selfish and won't have anything to do with you. It's a long story, and has no place on this list. FSJ's are more fun,...
I may be opening a can of worms...but aren't there two types....the stock one is a variable resistor, the type "Harbor Fright" sells is some gas/liquid...
They do have mechanical gauges as well. Those work on mercury I think just like the thermostats in your house. Just takes a tube instead of a wire to hook...
Had a lifted Chero with rattle can camo paint job drive down my street 3 times today and park a few houses down. Belong to anyone here? I'm on Tanforan dr. in...
It might help if you hosted the pictures yourself or somewhere else. Cardomain is known for millions of pop-up ads and stuff. I avoid it like the plague. Also...
If someone needs a smog pump for this vehicle, I have a couple of extras..... Mark H 303-815-7474c From: jeremy holden Sent: Tuesday, June 02, 2009 6:24 PM To:...
I got her up and running yesterday. Today I sealed up the rear differential and put her in gear. NOTHING. No response whatsover. Ok..I checked the tranny...
it may not have enough fluid in the torque converter, either because it was run dry or because the pump is failing. This is just a guess but it sounds like...
Any leaks in the tranny/transfer area? It's not odd to have a dipstick read full on a cold engine and empty on a warm running one. Just curious where the...
Hmmm. Ok. This morning I started her up and let her run for a little bit. Then I tried running through the gears again. Still very sluggish when I put her in...
You should at least check the tranny filter, and if the level on the dipstick is still low, add more fluid. Not sure what order you do this in, because...