I haven't read all the threads and replies yet, but something a lot of people forget is to change the in-line fuel filter. Also, a lot of senders are not ...
my first thought is a bad or loose connection. if memory breaks when in the ON or run position, it can cause things like this to appear. check the harness for...
OK, let's think "outside the box" - this is my own personal opinion (I do have the right to change my opinion at any given time) and it goes something like...
Marc, sounds like your 93 is doing a similar thing to my SO's 92. But ours only comes on at start up and I can clear it by turning the ignition off while...
I'd like to take off the shift knob in order to refurb the console pieces and put in a new indicator ( pricey little buggers ) but I don't want to break my...
If it's an automatic, the button that you push in to move the shifter can be "popped off" then there is a little "E" clip inside. Remove cap, remove E-clip...
Steve, The CCM and cruise seem to be separate problems, but who knows? I'm not TOO worried about the cruise control, I can live without that, but I do get...
Thanks Marc, from what I can tell, the cruise is disabled when I have the error indicator lit. My SO came in a month or so ago and said the cruise was out....
assuming auto trans here... the button comes out by pulling it straight up and out..there is a snap ring under it, that actually hold the knob on.. remove...
In your owners manual, if you still have it, details how to get to the shift indicator. There is a screw under the front cup holder, remove that. Remove the...
TIP: Indicator "needle" is just an over-priced piece of plastic that you can simply paint with fluorescent spray paint for a nice appearance. If you want 100%...
Hi! I'm thinking of changing the gears in my rear end to 3.54's, currently have 2.53's? Will this effect the main computer that controls fuel etc, if so what...
Pulling the shifter off of the automatic does not give you access to the shift indicator. All that does is remove the lever. You have to remove the console...
Thanks Greg I have not checked the in line filter yet, will do. Rog ... __________________________________________________ Do You Yahoo!? Tired of spam?...
you might want to grab a new C clip to install on the shift shaft. the old one will be loose and pop off later when you grab the shifter one day...not a big...
this inline filter is hard to check and tell what shape its in. it has check valves in it, so 90% of the trash is trapped in it and won;t shake out. its a...
hi gang, i wrote some time back about the horn not working on wifey's 84, i ordered a new relay and the contact plate in the steering wheel in hopes i could...
Just beginning on this diagnosis so let me ask the obvious...Have you put 12v right to the horn itself to see if it's working? Good luck! Russ(GOT14US) ... ...
what about the fuse right there next to the horn relay??? check that...then, pull the horn button off, pull the wire, and ground it right there inside the...
sorry I can't be of any help with the horn problem - but until you get it fixed, you should put a bumper sticker on the back window that says, "HORN BROKEN,...
How can I lower the antenna? it is dead not even a noise. withg the new flow thru I'd rather listen to the pipes anyhow. with the antenna up I can't put the...
John, get on your crawler and look under the car where the antenna is located. You can access it from there. John <vezero@...> wrote: How can I lower...
I'd first double check it's the antennae and not a loose connection or fuse. I'd check the connections hanging from the antennae under the car. make sure the...
The first question I have to ask is what year is the car. If it is an 88 or later you can remove the mast to get the thing out of the way as a quick and easy...
Lee, How did you set the reply to on your posts to be no_reply@yahoogroups.com? I've pretty much lurked here since I joined but now that I am posting it looks...
Hi All! I swapped my 2.59 diff gears for 3.54's and of course now my spedometer is off 25 MPH. Is there a way to synchronize the spedometer to the new gear...
Go to Eckler's site. Item # 35073 Speedometer Calibrator $170 Used it on my '92 when I upgraded to 3.07. You will need mileposts to gauge your current ...
One possible solution could be a Hypertech Power Programmer! I also have a 95 automatic and when I swapped the 3.07 gears for 3.73's that's what I did, and it...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
