Has anyone had difficulty with a "Power Gear" slide slowly coming out while going down the road. Three times today I had to stop. put the tranny in Neutral,...
Thanks folks, I bought an optional FM Relay adapter that allows the FM output of the Sirius radio to plug directly into my radio at the antenna input. Thanks...
Bob, check the brake lever on the motor. Our 03 had this problem and they found the brake lever was vibrating to the neutral position, while going down the...
Bpb, there is an automatic lock on the motor. Yours is not locking. You may be able to manually move the lever to the lock position, but it should do it...
Find the slide-out motor and the manual brake release lever is on one end and it may be covered by a rubber boot or sticking thru a rubber boot. The brake is...
My 2005 38N does not do that so there may be a short in the ignition switch. Jerry H 2008 38 N Enjoying winter in Florida To: bounder_diesel@yahoogroups.com ...
Mail system won't deliver to your address. Supect attachment is the problem. If you want slideout maintaince manual, give me an address. George ... From:...
I finally removed the ice maker, itself, not made at all easier by a PO who, after using a screw a solid inch longer than original, managed to make the...
Kelly; You just got to love how some things are put together. Some of the post said how they install the new tubing,can not remember anyone saying what kind of...
Copper...good, no, GREAT thinking! I even have some left over copper from my water heater debacle. That awning hook comes in handy for all kinds of stuff. I'm...
I should have told you that what I used was picture hanging wire. Small stuff. Comes in braded also, which is really flexible. My spelling is not good. In...
I just thought about something. It's going to be interesting, and may require some invention, to construct a copper line connect to the solenoid, which was...
Kelly, You could just run the Ice Maker in the manual mode by unplugging the solenoid and pouring about 6 oz water into the ice cube area from a plastic cup. ...
Kelly, you should be able to get copper compression fittings from any good plumbing supply house. Be sure to fasten the copper tubing down so vibrations going...
Have a 7.5KW diesel Onan gen. When I statr it, it runs for about 30 sec. and stops. Start it again runs for 30 sec. and stops. Has anyone had this problem?...
John Do you have fuel in your tank - Happened to me once and discovered that if my tank is around 1/4 or less the gen will not run - Safety thing. Ken Rupard ...
John: Look at the lights on the gen set, out front under the hood. Boy I have to think, think there is a green and red one. I have to look at some info. ,but...
Hi John; Well if the fuel level is Ok. I found the Manual and can send you a copy of the Troubleshooting page to you if you like.. Then if needed, I can look...
I have a question for the group. After years of monthly mailings I finally broke down and joined Good Sam a few yars ago. Since then the avalanche of mail has...
Gary: I also feel that the Life Time Membership would not fit our life stile. I do use there road service, have used it twice and was happy with the Service....
Check the coolant/anti-freeze level. There is a reservoir under the cabinet you can't see unless you remove a panel, and if there isn't enough fluid in there,...
These things affect it. Coolant level oil level fuel tank (coach) must be greater than 1/2 or so Make sure the circuit breakers, on the gen set, have not...
I've done my best to feed a thin, bendable wire through the line, as it is still mounted, so if nothing else, I'll be able, in theory, to get a new line to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
