... I have a 2002 Bounder with a Allison transmission does not change gears (I'm in limp mode). I'm stuck in Blythe , CA and no facilities are open do to the...
I have an 05 Bounder 39Z on a Freightliner with a Cat 300. The next time I change fuel filters I plan on doing it myself. I understand that the system could...
In a message dated 9/4/2006 2:30:52 PM Pacific Daylight Time, Bob@... ... This happened to me on one occassion and all I did was put it in reverse, ...
RBarabino@...
Sep 5, 2006 2:35 pm
2138
Don, yes, you must pre fill the fuel filter before installation. That should do the trick. The primer pump would be installed between the filter and the...
Well, we survived Ernesto without any problems. Okay, one compartment had water enter it, but that always happens in deep water, I'm just too lazy to seal it...
Hi Kelly, We rode-out Ernesto in Jersey City, at Liberty Harbor RV park and we got rocked around Saturday pretty good. The jacks that have a grease fitting...
These have no grease fitting, and they're always oily, so it wasn't like they it was rusted. We've been using them daily for a month or more. Before we...
Hi Kelly, Rod & Pauline posted the fix, they have a 98 D and it is likely very close or identical to your jack system. However since they are Aussie's, they...
Hello Kelly Over the last 6 years of spear-menting and living life (as large as I can live it in a 39Z)I have had ocassions where one or another of my jacks...
Jim, it seems the D site keeps folks out of the tips area unless you're a member. Do you have this info handy? You can hit me off- list, though it might be a...
I see why some really dislike the customer service they've received from this company. Or not received, as in my case. Granted, when I called at 8 PM last...
Does anyone know where to obtain or order the centers for a 2003 Bounder Diesel wheel "hub cap" Hit a few bumps on the last travel day and lost one... I will...
After researching the forum regarding batteries, I bit the $$$ bullet and ordered 4 Lifeline batteries for my 2003 Bounder Diesel 39Z. Every solution brings a...
After researching the forum regarding batteries, I bit the $$$ bullet and ordered 4 Lifeline batteries for my 2003 Bounder Diesel 39Z. Every solution brings a...
... rumble lane. I got centers from the dealer, but modified them for security. I drilled a hole in the center, cut a 1/2 inch aluminum angle to span the...
Bob, I posted pictures in the Photo section of this group of our installation of Lifelines under 'Boni's 2002 Bounder 39R', or something like that. We used...
Boni, Your photos gave me my solution. I went to Lowes and bought some steel strap with 3/8" holes. Cut it into 4 sections and ground off the sharp edges. I...
Well, after hunting in Elhart, IN, for two days and finding nothing but aggrivation and no help, we decided to head out. I called Fleetwood, and whadda know,...
Kelly: If you went to Sullivan's RV in Decatur, I'm sure you were pleased with their work. The last time we had to take our Bounder back to the factory in...
Yep, Sullivan's it was, they were good to us. Had places to hook up if'n you had to wait. Nice. We were much better off than some others waiting there,...
Broadcast TV antenna notes Since after leaving Vegas about a month-and-a-half ago, television broadcast reception has been flaky. The booster is working, as ...
Hi Kelly, Just in case you didn't get the TV antenna working right, you may find the cable that goes down into the roof can be pulled up just a bit. On the...
Hi, Im New to this forum. i am about to pull the trigger on a New (2006) 34-H Bounder Diesel. The monday deadline approaches and my feet are getting chilly to...
... Hi, Dick. Welcome to the forum -- and I hope you don't get "cold feet" on that Bounder deal. I have an 'old' 2004 with the low ceiling and a Cummins...
Hello Kelly Last year I solved my cctv cable/electic wires and other devices that have to enter via my roof. I bought a 1" PVC base plate which is approx. 4"...
Yet another RV unfriendly city in the Chicago area: http://www.dailyherald.com/story.asp?id=230922 I guess we should be getting used to this by now, but if we...