Hey Jason: The engine runs very well at idle and at full power. It is during acceleration that it stumbles and boggs down. I am going to install a new ...
Hi, all. Im looking two buy some tires for the back fo my 1968 baja swing axle. single port 1600. Im thinking 29" by 9.5" tires would be ok with the stock...
I run 35"x12.5 on 10x15 rims ... From: "superv414" <superv414@...> To: <bajabugs@yahoogroups.com> Sent: Friday, October 01, 2004 11:05 PM Subject: Re:...
35x12.50??? what motor and trans. are you running? ... _______________________________ Do you Yahoo!? Declare Yourself - Register online to vote today! ...
turbo type IV and a 70 bus with a changed 4th ... From: "corey cothern" <coreyc72070@...> To: <bajabugs@yahoogroups.com> Sent: Saturday, October 02, 2004...
yeah i guess that would do the trick......fun too i bet! ... _______________________________ Do you Yahoo!? Declare Yourself - Register online to vote today! ...
i think it's intigrated, replace the arm... Mike ... From: OurBug To: bajabugs@yahoogroups.com Sent: Tuesday, September 28, 2004 9:08 PM Subject: [bajabugs]...
29 would be fine,, basicly a a 235/75... i would go 30- 9.50 , would still be fine for power. Mike ... From: justaguitardude To: bajabugs@yahoogroups.com Sent:...
is it the motor or wheel?? check lugs and drum nuts in rear. it may be valve clatter, or pinging... Mike ... From: Patrick Adams To: bajabugs Cc: bajabugsrule ...
Hi all, Does anybody know what part # filter fits the small oil pump mounted fiter base? Also, my car shifts ok in 1-4 but I cannot get it into reverse. The...
Try a purolator PL 20252 for the oil filter; works fine for me. With a T-handle shifter, push the button with your thumb and put it in second gear; DO NOT...
Robert Edrena Jones
famjones@...
Oct 3, 2004 1:45 pm
13264
I tried all 4 gear directions while pushing the button and they all result in a fwd gear. The trans is supposed to be a close ratio unit and it appears to be,...
I'm running 235/75-15 BFG Allterian T/A's, A basicly staock 1600dp, stock suspention w/ turned bars on my 69 Dave In a message dated 10/1/2004 1:08:16 PM...
street69baja@...
Oct 4, 2004 11:05 pm
13266
could it be the bushing at the shift coupler needs replacing? jason ... _______________________________ Do you Yahoo!? Declare Yourself - Register online to...
i top out at about 75-80mph on the freeway. but i dont have any weight either. jason ... __________________________________________________ Do You Yahoo!? ...
Hi, may ask what tires you running in the front? I upgraded the rear now.. Im ready to get some new front tires. Id liek some durable tires.. the guy at...
Thanks guys, I found reverse finally. The bushings may be worn also but I'm happy that I can back up now at least. I'll check the bushings after I fix the...
Howdy all, Being this is my first Baja I'm looking for some suggestions on where to go. I'm in the Ventura/Oxnard area (NW of LA) and was looking for places...
Howdy again, I'm looking for a tow bar, but the front end may have been widened on my Baja. I tried my friend's clamp-on tow bar but the skid plate & bumper...
I'm running some take offs from my street car 205/60-15 directinals. They will have to do for now, but I plan on using BFG Allterain T/A's in the front when I...
street69baja@...
Oct 6, 2004 11:37 am
13274
Hey Ya'll: I'm still trying to get this Beetle to run good. Today, I replaced the points, condenser, rotor, and rotor cap. I bought a new fuel pump. The...
im running LT235/75R15 Mud Dueler M/T's on the back, and stock sized on the front. so, for a stock 1970 baja, how big of tires can i get away with on the front...
Hey Jason: I think you are correct. I have replaced the carburetor, fuel pump, coil. points, condenser, fuel line, fuel filter, sparkplugs wires and engine...
hey Ya'll: I have replaced the carburetor, fuel pump, coil. points, condenser, fuel line, fuel filter, sparkplugs wires and engine oil. The problem still...