HI Dale.  Your question is really a good one, Dale. Thanks for asking.  If I were still working at Mobil Research & Development Corporation I am sure I...
Well, After a few months of shopping around for Older airstreams I learned of the Avion and I became a fan. Pat & I just purchased a 1972 28ft'er that shines...
Steve and Pat, Welcome to the Avion forum! As mentioned in our welcome message you received when you joined, we have a wealth of information in our message...
The propane gas supplier for our campground and homes in several counties cautioned about messin' around with the regulator settings. He contends that the...
Bob, I believe you misinterpreted the prior messages. I don't think that folks on this forum were suggesting to set the regulator high to get a bigger flame. ...
Rol, Without re-reading the previous comments, I seem to remember that you are correct about what was said now that you brought it up. However, the discussion...
Hi Bob. If you are uncomfortable checking the pressure adjustment on your propane regulator, maybe it would be better to just buy a new regulator which...
Hi again, Bob! I can understand being reluctant to fool with the gas system! It is very easy to end up with a dangerous leak if something isn't fastened...
I'm so happy to have found an Avion group. I have just come into ownership of a Avion, serial # is 67-28059, model # T-28. This is about all we know, thinking...
Mary, Welcome to the Avion forum! You will have a lot of fun with your T-28! As mentioned in our welcome message you received when you joined, we have a...
Thanks, Rol. Sounds simple. Might try it. Approximately how much is a regulator? Maybe I should buy one and be done with it. Cheaper than having tech...
Hey, group I need advice: A P.O. used screws to secure the overhead ceiling light and sadly, the screws were too long! Consequently I have two screws sticking...
Hi Bob. Just so I am clear how the propane is connected to your trailer.. I have a few questions. 1. Are you using a large commercial propane tank...
Hi David, Welcome to the Classic Avion Forum. If the "caulking" that is used to seal the holes in your roof is not silicone and seems in good condition, you...
Hi All, Great topic timing! I built a water manometer and just finished testing my pressure at the stove. But I'm confused about what the readings are telling...
Hi All---AGAIN! I forgot about the ID protocol. Sorry. But as long as I'm back on, let me add that none of my gas appliances are working after sitting around...
Pat, Your small TV might use a fair amount of power, measured in watts, compared to your laptop pc. If that is true, you might consider using your laptop to...
Hi There should NOT be 4.0"wc difference when you turn the second burner on. Your regulator is probably defective or you have a restriction in the propane...
Bill, Welcome! It sounds as if you may have a partial blockage or failing regulator. The pressure should be the same or close to the same with the back burner...
Bill, I know we usually don't copy the others email to reply, but in this case, it's appropriate. >Are you using a large commercial propane tank provided by...
I'd put in poprivets and dab of caulk over them. There's a very good RV caulk. Name escapes me now. I have some at campground, so will reply to that next week...
Make sure the pop rivet is aluminum with an aluminum mandrel so nothing rusts. They also make "blind" rivets that are completely sealed at the back end, as...
Hi All, Thank you Bill and Rol. Tomorrow, I will blow out the gas line; (no kinks found Rol). If that does not solve my up/down gas pressure inconsistencies,...
Hi Bob. Copying a statement from a previous post to respond to a question is perfectly appropriate, Bob. In fact, it's probably the most efficient way to...
The name of the stuff is Parbond made by PAAR Technologies, LLC, Elkhart, IN Tel. 1-866-476-PARR. Many camper places with bigger parts dept. carry it. It...
Bill, before I knew that this forum existed, I discovered that the forward screws that hold the awnng mechanism to the AVION were letting water get in. I...