Usually there is a anti-rotate ball in between the clutch push rod and the basket which is located in the center of the clutch sprocket. Maybe this ball fell...
... parts but I may resurrect it as well as it is mostly there. Having two identical models of the same year lets me see what may or may not be OEM equiptment....
Thanks, - Yes itwas pointed out that the intake mainfold is probably from an 82 model. I checked the parts pictures and looks like an 82 carb too. Not supposed...
I had the same problem when I replaced the clutch on my 465. It turned out it was the adjusting screw in the center of the clutch basket. Todd ... and the...
after i got my bike it was froze also. clutch pads were dry. took em out and soaked them for a day loosely in oil and reassembled dripping wet. also i found...
My 490 had been stored for 5 yrs, clutch was stuck... I push stated the bike and went thru the gears for about 10 minutes and it freed itself.. Donnette Bowman...
Just purchased a 1984 IT200. Got it for $75 !! Anyway, it's rough cosmetically but starts on the first kick. Engine seems to run strong but when you give it...
I'll do my best -- I'm an IT (information technology) Director ;-) Anyway, starts right up. Idles Good (not super smooth but good). Feels strong while idleing...
Ok , take your carb off , then , your intake manifold . Next , pull out your reed cage and look to see if the reeds are closed all the way . There should be no...
Check the pilot and main jets for clogging. Float level, and exhaust flow,,, silencer may be clogged. ... __________________________________________________ Do...
Thanks for the info. We pulled the reeds today at lunch (long lunch) and they were fine. I'll prolly call you. I really appreciate the help. I think this...
I've got the exhaust header being fixed tonight (some pinholes about 2 inches up from the motor). Also, is there anything I can use for a gasket where it...
I assume it's the exahust manifold connection (where the pipe connects to the engine at the front of the engine). Thanks! gb ... header being fixed tonight...
you might find jet sizes on bike bandit also.. float level is about level on the float arms. roughly ... __________________________________________________ Do...
Don't bother with the Yamaha gasket. It is normally a very expensive steel shim that doesn't do much unless everything is perfect. Chamber seal is good if...
Also the exhaust comes out at different places I believe. I have an 86 (I think)and it comes out center of the engine, whereas other years have it skewed off...
From '82 up all the 175-200 engines look the same. ________________________________ From: YamahaIT@yahoogroups.com [mailto:YamahaIT@yahoogroups.com] On Behalf...
I'll be tearing down the pipe tomorrow at lunch and see if it's clogged. Hopefully it is! Anyway, I really appreciate all the help. I'll post some picks of...
Hi all, I have the chance to buy a 1977 IT400 for a project...(running bike)... Are parts available for this year bike.... From what i see at powersedge.com...
Also check fuel flow from petcock, and that the gas cap is venting properly. ... __________________________________________________ Do You Yahoo!? Tired of...
i have a cylinder and pipe ... __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection...
i have an 1977 it400. i bought it for the title. but i think most of the internals are the same as the YZ. i have one of those too and i can find most of the...
