I just use a gear puller and some 8mm X1.25 threaded rod and nuts and washers .. The cases have tapped holes in them for seperating the cases,,,Usually. ... ...
Newbie here... Just acquired a 76 IT400 which I plan to make street legal. Need a little help locating an original front & rear fender, original tailight, and...
Everyone has their opinion but I've been running Yamalube R at between 40 and 50:1 for over 20 years without any trouble in my ITs, YZs, Can-Ams, KTMs etc....
If you care to spend the time to educate yourself go to www.maximausa.com and go to their technical tab and read up on oil migration as well as a bunch of...
Thank you all for your suggestions - I found the information on www.maximausa.com to be most useful helping me to sort it out. Dana ... heat ... blame ... ...
The Barber Vintage Festival is supposed to be a good one. It ought to be one heck of a weekend. The museum alone is worth the trip. I'm going to be there. ...
Hi dirt bike dude, I'm no guru, but have recently rebuilt my IT250H. I would recommend stripping the engine yourself. if nothing else it is a great learning ...
86 IT200S Parts available. I had to swap out the disc brake system for a drum brake system to qualify for Evolution Class racing. I have the following...
I have a 77 IT 175 and would like to replace my cylinder to carb rubber joint. Any ideas on where I can find a NOS or repro part? I have seen the carb to...
Good luck. I don't know if yours has the port on it but mine does and the only place I've found it was on ebay for about 80 bucks. I ended up taking mine off...
Shoe Goo (don't know if it's available outside the US) works wonders too. A friend of mine has been off roading for years and swears by it. Since it's black it...
That series of carb needs to be around ¾ - 1 ½ turns out. If it wants less then your pilot circuit is dirty, your pilot jet is too small, air filter has...
11/2 turns out from fully seated is a good starting place. ... From: "geob32001" <dgbowman3@...> got an 82, it250j. what position is the air/fuel mixture...
Man I wish I knew.... I've always looked for the 86IT200 setup but never actually been able to buy one. A while back somebody suggested upgrading to something...
Hi - Is there anything to watch out for when changing the fork seals on a 1986 IT200? I've done fork seals before, just not on this bike. Thanks! Dana...
Hi Again - Want to touch up/spruce up my bike a little over the winter. I believe that the engine and the exhaust on the IT200 were painted in a semi-gloss...
So is Duplicolor Ceramic 500 degree low gloss black ... From: lee buchanan To: YamahaIT@yahoogroups.com Sent: Friday, October 19, 2007 5:52 AM Subject: Re:...
My neighbor has a 83?? IT490 and I am curious if members of this group would be interested in parts. Please let me know how many are interested. Thanks...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
