Hello Everyone: I have been looking around for parts for my 86 IT200 and have found some good parts sites on the net. You can look up parts from copies fo the...
Hello Everyone, Sorry about the previous post it looks like the decal thing has been beat to death. Anyway a couple of questions for everyone out there: I...
Not sure about the pipe problem and for the Oil Ratio I was told to use 40:1 and I even bought that little cup thing to help mix. I think a Poll would be...
Hi Mike, About pre-mix, To me this seems like an area of constant debate. Everyone has a opinion on the best ratio to run. Most ratios I have heard of run ...
I'm currently experiencing the same problem w/ the DG pipe on my '82 IT465. It seems that the angle of the pipe when it's in place and clamped down doesn't...
Yep, that is the same problem I am having, the angle of the male engine exhast port does not line up well at all with the female exhaust port on the pipe....
Hi friends, I noticed the problem you are having to allign the exhaust as i had the same kind of problem in the past. In order to seal properly male and female...
Hey thanks for the idea, I am going to look into this and see if I can get it work like you described. Mike ... male ... done ... where ... put ... and ... cut...
That sounds like a plan to me! I just posted a pic of mine in Photos area and will take pictures as I do this project. Hopefully it will work as yours did....
On my 1986 IT200 I have just replaced the front disc brake line and cleaned out the master cyl. and installed new fluid. Now it will not pump up.... Any tips...
Bleed the brakes in the normal way 1. Open bleed screw at caliper 2. Pull brake lever 3. Close bleed screw 4. Release brake handle Repeat this until all air is...
I had the same problem in the past. It took me hours to get the front brake working again after changing the line until a freind helped me with the following...
I have heard about a million different ways to bleed brakes on bikes. Here are a few tricks that I use in the more difficult situations. Go to the following...
I had a buddy that put a 230 kit on his 200, and he was quite pleased. I only rode with him for a little while after he put it in, so I don't know long-term...
I'm looking for a parts motor for my IT465... if anyone comes across one please let me know. I'm really interested in the lower end as mine has some damage to...
Hey I have a bunch of stuff for sale on ebay. Im cleaning out my inventory.. Complete engines. Mint fenders.. brackets.. cluthces.. A few motorcycles..lots of...
check the auctions to be sure.. but I believe the only seat I have is a ct125.. not sure if it will fit or not.. tanks and seats are hard to come by.. easy to...
Looks like you have a lot of stuff, too bad nothing I can use on my IT465. Thanks for the info, D. ... From: db7863 [mailto:db7863@...] Sent: Wednesday,...
Im a little late in replying, but if it can still help you, the main differences between the 1980 IT 125 and the 1981 IT 125 are the colour(the 1980 or IT125G...
Hello- New to the group & glad to see it exists! I need the plastic frames that the filters wrap around that go inside the air box. I also need the foam...
Welcome Pete, I might be able to help you out... I have a bid on a 1982 IT465 air box but I don't know if it will have the insides or if it will fit? But if it...
Thanks David! Yeah, I like riding mine... plenty of power & a plush ride to boot. I get on these newer bikes & the seat is like riding on a 4 x4. It doesn't...
