I did an experiment with my SD - normally a green light labelled "battery" is on when the battery is connected to the charger. When I pushed in the emergency...
I think the charger used in production of the SD is now the Delta-QÂ Â QuiQ shown here:Â http://www.delta-q.com/products/quiq.shtml They appear to be used in...
When I got my DeltaQ replacement for the BC-2 charger (maybe 9-10 months ago), the official instructions from ZAP said to NOT use the rubber grommets. There...
we in mn have added a 7th battery and charger for a pk. results are very good. 45 mph on level ground and 40-50 mpc. We've operated it for 2 weeks with no bad...
Yes, lots. If the SD has an Alltrax controller the fully-charged voltage may be higher than 90V, so the 7th battery needs a switch or solenoid to keep it out...
I was at ZAP in Santa Rosa last week - they still have the grommets in use as washers which does nothing, so I can see why they would say not to bother. My...
See also http://xebraworld.com/Â .. Dale and Ron may have been the first on the block to try 84V in the SD. ... From: sylvanslumber <sylvanslumber@...> ...
Yep, we sell kits for this upgrade, for both the PK and the SD as well as a line of new vehicles already converted to 84volts (v84x). -- Sean Rarey GPEV ...
Yes< I put a 7th battery with associated hdwe behind the seat in my sd, and I am having great results! My top speed is about 47mph ( I have 13" tires) and my...
Really there is no need to give up the back seat of the SD ; to put a seventh or an eight battery in th vehicle.  You can also move the relays out of the...
I see F10, a 25A fuse in the charger circuit on the 72V ignition schematic. If that fuse is open-circuit, you will have a red fault light, and no green...
I heard back from DeltaQ (in response to my email and graphs). First, they are willing to replace, if defective. But, they wanted me to first check the voltage...
I need some advice. I have read the archives, but am more confused than ever. What do I need to mount 13" tires all around on my '06 PK? Can I use the stock...
You need 13" rims to mount 13" tires; stock rims are 12". The ADRs we usually use are back-ordered at this time, we hope to have more soon. Our 13" tires will...
We have ADR rims on our Xebra, rear only. There's no real advantage to putting one on the front, other than "bling" effect and that's pretty well hidden. The...
25 amp fuse is likely under the hood up front ... From: Ray Wells <raywingit@...> Subject: Re: [Xebra_EV] Fault light on To: Xebra_EV@yahoogroups.com ...
On our 2006 SD, it is in the rear. See photos in "SD Charger Wires & Fuse." It's the grey thing in the lower half. Also, taken apart, and a closeup. ... ...
Gnarly.     This is the 25A (50A?) 72V fuse - so how is it different from the 12V fuses? It looks like bigger spade terminals. ... From: dgpretzel...
I have the 12V ignition, (now modified to 72V), and the silver charger, - I don't think it has the 25A fuse but I'll take another look. ... From: dgpretzel...
... it different from the 12V fuses? It looks like bigger spade terminals. ... I'm thinking now that the grey device is just a connector, and not any kind...
i have a 4000 watt generator that i put in the back of the zap truck and use it to charge the auxillary battery(goes to the guest charger)Â while going down...
I put the 13 inch rims on my sd. The only problem that I had was that I could'nt get a wrench on the bolt so i just drilled out the rims with a 1 inch bit to...
DG, what you're showing in the last two photos is not a fuse, it's an Anderson Powerpoles connector. Certainly the corrosion will give your charger fits....
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
