Question: Is there anything I need to be concerned about when I do this? I have a '95 1100. I am about to replace my rear tire. However, I replaced my stock ...
One further distinction is that the 400 has wire wheels and the 535 has alloys. The Virago 400 is very popular here in the Philippines as they are all Jap...
Hi, As it so happens I have been running my 250 hard for the last couple of months and run her on 85 octane unleaded. She returns a consistent 35 km/litre....
i have an 97 535 ,it has wire wheels,all 535's sold here have wire wheels, the XV500 had alloy wheels Tyler Pennock # 380 V max Owners Association Eastern...
I have my own conceptions, but what are the real advantages of shaft drive? Are there benefits of chain or belt drive too? Bret '87 XV1100 ... From: Sandy...
I have a question about syncing the carbs on my 1981 750. Do I need to buy two vacuum gages, or can you alternate the same gage and adjust till you get an...
You don't even have to buy a vacuum guage if you don't want to, but either use a factory made Manometer, or build one, it is very easy to do and cheap too. ...
I had a moment of triumph!! My XV700 (1985) started right up after reinstalling the carbs. However, I still can't seem to get the front cylinder to fire and...
Thanks! This great! I whipped one up, but I'm sort of at a loss how to hook it up. The instructions say 1/8 ID tube. I am assuming on my '81 750 I will go to...
ladies and gents, I have been lurking around the group for a while now, but I havent posted in a while. I got a 82 xv920 out from under a tarp in someones...
Hi Artie, I'm totally ignorant when it comes to the earlier Viragos, especially those equipped with fuel petcocks, so I'm not even going to attempt to answer...
I've determined that those nipples are the correct place to hook up on my bike. Any reason I can't use 1/4 ID tubing (which will connect right up to the...
Hey all, Thanks to those who offered feedback re: my issue with backfiring. I've been on the bike over the past few days, and for whatever reason, it seems to...
I would think that as long as the seal of the 1/4 ID tubing onto the nipples was not leaking, that would be sufficient. REMEMBER SEPTEMBER 11, 2001 (CLICK...
I honestly have never needed to lubricate a speedometer cable on a motorcycle, but have done it many times on other types of vehicles, by using a graphite...
my speedometer does the same thing. You can lube the cable, and you should from time to time. Just disconnect it at the speedometer and pour some light oil...
Mine does the same thing, but only in cold weather (October-April). It recently stopped althougher. I tried replacing the speedo cable; didnt work. It was a...
When was the last time you changed your ignition wires? As they get older, they cause more Rf-leaks and electrical noise. A new pair might fix the tach...
Thanks, Chris! Well, I haven't had the bike that long, so there's no telling. I'll look into it, but the resistance is in specs on both leads. This happened...
I Have a 1982 Virago 920 with digital dash 27,000 miles for sale not has been setting in friends garage need to sell in Va 20180 500.00 OBO thanks greg...
i just joined this group and the pic's dont not work .....i have a 84 xv 1000 like new it has 9500 miles on it nice ride had two harley's sold them..now have...
Does anyone know where can I buy an air filter cover for my 94' XV535? My bike got knocked over on the street in the city. Looking for some replacement parts...
The Orange wire is the correct place to measure.(negative terminal of the coil, though it runs straight to the ignitor, so you could measure there. i would...
Howdy all. Having decided that the buffeting I get on my 96 750 on the freeway stinks, I want to get a windshield. Does anyone have any opinions as to which...
Tommy0, I am (re)new(ed) to bikes and the mechanics, but what you have sounds like a badly corroded wire and/or contact causing the delay, or possibly bad...
I have the Yamaha EOM Classic for my '95 1100. It is a look over, not look through the windshield, style. While the air is diverted above your eye level...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
