Hi,Sebastian, Last evening,after about 2 hours of testing,suddenly, the system started to work,and is still working, flawslessly.The owner took the car and I...
I am helping a guy install an MDI interface with an RNS-510 into a 2007 GTI (North American Spec). The MDI is talking to the RNS-510 just fine, but there is no...
The new addresses like 2E got introduced pretty late in the PQ35 (Golf 5 etc.) platform,. therefor the "early" gateways did not support it. IMHO the only way...
Thanks for the help, I believe the 'L' CAN gateway is probably the right one since that is the one for the Tiguan which can come with the MDI. Should 2E be...
As I tried to explain already, older version will just not work. The long coding table which youn refer to does indeed not list that address but this isn't a...
Ok so it just flat out doesn't show up then with the older CAN gateway. Do you believe there is any advantage to going to a Q or R module on a Golf? The L...
Hi. All. I have a customer that wants blutooth on his 2008 A4 (8E chassis) It is fitted with Satalite Navigation. How do i activate the system to use ...
adrian@...
Jun 2, 2008 7:55 pm
27509
You have to simply added a BT-interface see Etka page and here: http://www.navplus.us/forums/showthread.php?t=7741 Regards Seve ... chassis) ... system to use ...
test ... Sorry I think I might have put this group as spam. Just want to test if I fix it correctly. [Non-text portions of this message have been...
Thanks for your help. Regards Adrian [Non-text portions of this message have been removed]...
adrian@...
Jun 3, 2008 9:32 am
27513
Hi. Does anyone knows how to deactivate DRL, and code comfort opening of the windows (if supported) on our 2006 VW 7H Caravelle ? Address 09: Cent. Elect....
There is a relay accessed through a small panel located below the radio. The relay is marked 94. Simply pull it out. Bob W. In a message dated 6/3/2008...
... From: Roches Drinagh To: support@... Sent: Tuesday, June 03, 2008 11:43 PM Subject: VCDS debug/log report Files are attached. Hi Folks, I enclose...
Hmm. Below the radio is the climate control. Below the climate control is the cup holder. Below the cup holder is the fuse compartment, and there is no relays...
Evening all, I'm having some trouble with a 2000 Golf 1.6 AHL, the car acts like it has an immobilizer fault (starts for half a second and then dies). The...
Hi, This sounds like the common ignition switch fault to me. Have you checked the voltages to the ecu? Dave. [Non-text portions of this message have been...
Which fault is that? No thats the plan for tomorrow as I didn't get a chance today. I've experienced issues with the relays before (109 for example) but this...
The check engine light keeps coming on, usually if I try to give too much fuel while cold, but not always. I keep getting a 17544 message. From the ...
Below the climate control and above the cup holder, there should be a panel (about 15x8cm) held with four Phillips-head screws. Take off the panel and the...
Hmm. Above the cupholder is some kind of "pocket" (about 7-8 cm deep), and also the hazard warning switch. There is no visible screws, but the "panel" seems to...
Hi. Matt If you look on the wiring diagram. You need to trace the K wire out of the cluster. It then changes into a W wire on the diagram to the engine ECU....
adrian@...
Jun 5, 2008 6:52 am
27524
[Non-text portions of this message have been removed]...
jkay2008@...
Jun 5, 2008 9:19 am
27525
Hello, I'm a new user of VCDS 805.0 and riding an Audi A6 4B C5 2.5 TDI engine BFC of year 2003 in France - Europe. When connecting the USB HEX-CAN interface,...
My '97 Passat VR6 died at a stop light today and would not immediately restart. After a few minutes, it restarted and then died after a couple of miles. When...
hi all i have in lt 35 2004 2.5 tdi with avr enine code the aba lights on but cannot get fault codes out no communication no response i beleive that the abs...