you have a bad Ground on the connector to coil pack. find a brown wire on the coil pack connector, cut it and run another wire from battery ground to the brown...
Tried to match some flip keys on sons Seat Ibiza 1.9tdi its only 2 months old. 17 instruments logged in using 4 digit SKC, it seems it accepted ok. By the...
I dynoed my car 2 weeks ago and my friend datalogged 1-2-3 during the runs. A few days after the dyno I brought my car to the dealer to have the gas tank...
Just disconect battery for a few second,and it will be gone,your old sensor is ok,I think. God luck. ... VAG ... opened ... oil level)is on,and stays orange,a...
Hi, On a 1.9 TDI 110bhp AFN engine (Audi A6), I have been running thru all VAGCOM checks as I think the engine is a little rough / down on power. Anyway most...
Hi Josh, You havent given us any details about your car but off the cuff.. you've got to know that a dyno can never replicate true enviromental driving...
Hi I have been using the Block 120 spreadsheet you have on the Ross-Tech site for a while and has proven really useful. However, please could you confirm...
Hi everyone: I check with my VAG-COM a Seat Cordoba, the problems are ,the steering wheel is to heavy even with the engine on and the little stering wheel...
Hi, I have this UK Golf 1.6 16V BCB engine 2003 year, 1J1 1E4. Marelli4MV G 4566 control module 036 906 034 DR It came in with misfire on number one cylinder,...
Steve I think you will find that it is trying to compensate for the carb cleaner in the manifold.if you leave it idling up to temperature and the let it cool ...
Tried to match some flip keys on sons Seat Ibiza 1.9tdi its only 2 months old. 17 instruments logged in using 4 digit SKC, it seems it accepted ok. By the time...
Hello! I was getting this 2 fault codes and i fitted a new injection pump,but now i'm not alowed by the imobilizer to start the engine,getting this fault...
hi! i have a problem i can't adapt a key in the bora GLI 2007 i'm using this... Key Matching Prerequisites: • All keys are either new or were adapted to this...
hi , have B5 audi and latest vag com 704.1, the follwing message displayed when trying to connect to: Airbag controller 15: cannot continue excessive comms...
Hi Nick, I cleaned the throttle with a small amount of WD40, not enough for it to run on, so would hope that didn't cause a problem. I tried a few more...
Try re- adapting the EGR. The EGR, and throttle body are linked together. Regards Adrian [Non-text portions of this message have been removed]...
adrian@...
Sep 7, 2007 12:54 pm
26098
I am trying to find the measuring block used to verify temp for the 01M after an oil change. The Bentley say's block 005. I was unable find the block. Thank...
Hi Adrian, Can you please tell me the procedure to reset the EGR with VAGCOM? MArelli 4MV G 4566 036 906 034 DR softcode 00031 Golf 1.6 16v BCB eng code...
From memory i think it is Engine (01) Basic settings (04) Channel 75? I think the engine as to be below 40 degrees? Regards Adrian [Non-text portions of this...
adrian@...
Sep 7, 2007 2:26 pm
26101
Try this procedure: http://wiki.ross-tech.com/index.php/Exhaust_Gas_Recirculation_%28EGR%29_Valve_Adaptation Regards, Andy...
Have you checked Instrument Cluster measuring blocks 24 to see if Immo is locked ?. It should read 0 in all 4 fields. If all zeros then it's most likely you...
hi, have scanned car B5 Audi and have following codes: 17965-charge pressure Control: Positive Deviation p1557-35-10--- intermittent 18010- Power Supply...
My apologies. The car is a 2000 VW Jetta TDI. The trans has about 35k miles and I am interested in changing the filter and fluid. I read that the proper...
Select -> 02-Auto Trans -> Measuring Blocks -> 005. If you don't see a temperature in the first field of the group, what do you see in that group (all four...
I reckon the problem was the EGR adaption, but why cleaning the throttle body upset it, I can just guess it's something to do with a change in expected...
... <snip> ... Injection quantities can be a strange thing to go by. It's not really something I'd look at when doing diagnostics. ... The issue here is a low...