Hi Jack, Glad to read you didn't get hurt too bad. Plastex works good. http://www.plastex.net Body filler will fill in the scratches. Search for a shop that...
If you just get the mixed paint, you can pick up the other things you need (usually reducer- but the place you get paint from can fill in the details) and put...
Tsk! I can't go 'off-piste' for a couple of days without this happening to somebody ! Sorry to hear your news Jack. Commiserations etc. A2 has had some success...
I certainly like the plastex but I wouldn't hesitate to stich some stiff non rusting metal wire across cracks by heating the wire and sinking it in from the...
Hi All, I fixed the aluminum barrel that had the two little tabs broken off. I drilled the tab area with a #53 drill and then tapped the hole, and put in two...
Hey Fool! I mean; Jack! Send me your Pay Pal address and I'll send you $75 to contribute to the fund to res-erect your Trophy in exchange for the the Aluminum...
Hi Friends, Nah, nah, nah Bro, I don't have anywhere near the where with all to tackle this. All I can tell you fellows who aren't fortunate enough to have...
I'm happy with my knob the way it is ;) Sent using BlackBerry® from Orange ... From: "PaulB" <pdb@...> Sender: TriumphTrophy@yahoogroups.com Date: Mon,...
Hi Jack, I was just wondering about you recently, as we had not heard from you in a while. Hey Brother, I'm sorry about your recent "Git-Off!". I hope you were...
Good Job Greg! I think my Aluminum knob has big "Majico!!", and will work for ever. (LOL) Thanks for the tip "Keem'o Sabbe", it sure sounds easy when you or...
Oooops! Bob is correct, I neglected to say which side. I need the pieces for the left side, as you're sitting on it. Oh! And I learned something that may be...
Hi Jack, It's easy for Kurt, just grab the aluminum knob and twist. It's only easy for me because I have a vertical mill and a 10 X magnifying glass. "I Pity...
Hi All, It was barely above freezing this afternoon, the sun hadn't shone for days and a bitter north-easterly wind was blowing...but to hell with it! I hadn't...
Honestly, when me and Mr T hit the deck, we were not going too fast. Maybe 15 mph, but we SLAMMED down. So here's the play by play. We were on a three-lane...
That was very thoughtful Bob, sorry I did not specify earlier. But....if they are Pacific Blue.... I might be interested anyway so you won't be left holding...
I've read a couple of reports of crashes in this group over the years and whilst riders often blame other drivers for doing stupid things, it is usually the...
Great advice Ken! My father was a logging truck owner/driver as well as a motorcycle rider and his advice was the same as yours. Quick stops for either vehicle...
Hi Jack, I'm very glad to know that you were not hurt badly. I also have no doubt that any one of us has gotten away with that small mistake a thousand times,...
