hello everyone I have had my 99 trophy 900 for three weeks (lovely to ride), and twice the engine has just died for no apparent reason. After a few moments it...
Hello all, I am a fairly new member to the group having bought a 1200 in yellow a month ago, and have been sitting back for a few weeks reading the massages to...
I knocked a drill off my workbench last night, and the bit scratched the right-side bag. What's the best way to touch up something like that? I have one of...
I have not heard from moderators or from the group in general so I am going to ask for help on a research project. Again, this is for a masters level class I...
It might help if I actually attached the forms! I need the info in about a week so I can write the paper. Thanks TERRY AICHER Director of Adolescent...
Hi all, i've just joined this group after buying my first Triumph - a '98 Trophy 1200 in British Racing Green - a week and a half ago. The mirrors on mine are...
Symptoms: After refuelling developed a misfire under load, isolated to 2 centre cylinders cyl 2 is not running at all, cyl 3 is making a contribution but not...
Due to taking the bike off the centre stand with the chain and lock still around the front wheel and forks (I'm putting it down to a senior moment!) I have had...
Bear with me on this as it is a bit of a long story. I purchased a 2001 Trophy 1200 last Thursday and was going on a 1,000 mile ride leaving friday am from...
Just picked up this week's Motorcycle News (UK), which has a big splash claiming Triumph are resurrecting the big sport tourer project from 2-3 years ago, to...
... to >improve spongy front end). Anyone out there done this recently? If so, what >weight oil did you use, and has it made a difference? Trev, Chances are...
I shuddered when you started talking about using lumber to set-up alignment. I don't know about all people on this list but I don't think I could find a...
I recently had a low speed collision with a car, which started to do a U-turn, whilst I was filtering past traffic in London. Luckily I managed to keep the...
Just aligned the wheels and found that the markings on the rear no longer match, one side is on a mark, the other side is halfway between the marks. Is this...
With sadness I have to sell my 96 Trophy. I have not had it that long but an impending divorce means that it has to go. I have it listed on ebay. It is BRG...
Hey Terry, I'm sorry to hear about the row 'twixt you, and your wife. That ultimatum really never works well for anybody. A spouse that says the bike or me, is...
So my 02'BBBB started giving me trouble a couple weeks ago during a Sunday run, I got nervous thinking I was not going to make it back. I read through messages...
BIKE SALE FOR DIVORCE: Terry L Aicher Posted "With sadness I have to sell my 96 Trophy. I have not had it that long but an impending divorce means that it has...
Hi, It's an '92 900/3, the carbs and airbox have been done, but the exhaust studs needed replacing.I bought 20 M8 nuts, 50 washers and 2 x 200mm 8mm allthread,...
As luck would have it, my upper line has been pinched by the forks/fairing brace and the right lower is leaking. Galfer makes a set of two lines that run all...
I have both a Trophy and a Thunderbird that I take turns riding. I am assuming the Thunderbird is basically the same engine as the Trophy only smaller, 900 vs...
After market brake pads. I have started my winter strip down and service on my 01 BBBB with 1200 miles. Both front and rear Brake pads are I estimate 75% worn...
Hello, I am a new member. I just bought a 1999 Trophy 12 that needs to be rebuilt(it was laid down on the right side). I know this is a long shot but I have...
As I have to adjust 11 out of 12 valves, and a few people have said removing the cams might be easier, I thought I might give it a go. So I have some...
Hi, I am about to buy a 97 1200 Trophy with 34.000 km's on next week. Before inspecting the bike, do you have any special recommendations other than common...
Anyone got advice on cracking the S/N code? I've got a '00 900 with a # of 111490, but 29155 seems to be one of the cutoffs for buying parts. Does this 6 digit...
Has anyone got a valve shim removal tool for sale second hand? I have removed the cams in the past and would like to add this tool to my collection.I don't...
Well, I'm back under the front fairing of my 98 900, this time it's that the taillights (usually) don't work. I previously had problems with all lights going...
