I cut my valence and installed the cooler on Friday. Took about two hours and went very well. That's all the time I had so I buttoned up the grill so I could...
Good information, Bret! Look forward to seeing the pictures and hearing about the results. Michael: Is there a way to post the message in a new thread; ...
I cut my valence and installed the cooler on Friday. Took about two hours and went very well. That's all the time I had so I buttoned up the grill so I could...
Thanks! I should have started a new thread with this. -Bret ... to ... tow ... bottom ... cooler ... wide ... the ... ends. ... about ... and ... of...
Bret: Why are you playing on the computor? You're supposed to be finishing installation and taking pictures of your TD-EOC so we can see (haha!!!) ;) - Steve...
Hi Bret, I like your idea with the template - I just cut one out using your recommended 22" length and the 3 1/4" height with the rounded corners from the hole...
Hi Mark, I used a DeWalt bi-metal wood/metal saw that also has fairly rough teeth. Don't worry, just keep the speed up in the upper end of the middle range...
I'm at work or believe me I would be working on it right now! Also have company in town for the 4th, so it's tough squeezing in time right now. I think...
Well, yesterday morning I got up early and finished the install, about another hour and a half. Also did an oil change and changed the filter element in my...
Bret, Great report and great results. One more testimony that Engineering does work. Waiting for the next Chapter. Ohh... has any of this found its way to the...
Thanks Fox. My plan is to do a write up with pictures in the product review section of DP when I get a little breathing room (if they allow it). Even though...
Hi all! Good to see all the activity and guys getting their EOC's up and running. I've been out here running hard, all KB'z fault! No excuses any more. LOL....
Jeff, My pre-EOC tranny temps are 175 towing when cool and when my ECT is steady at 203 (OEM guage) .... When my ECTs go up (235 ....) my tranny temps go to...
Hi All, My EOC will be arriving in rainy Maryland this Friday. I decided to start slicing the valence tonight .... [>:)] I posted pictures on this site for...
Mark, is there a specific name for this SAW <http://autos.ph.groups.yahoo.com/group/TD-EOC/photos/view/d487?b=1> ? Will it cut a straight line without the...
Thanks Mark....Hope your install goes well. One tip I would offer is to make sure the hose fittings are clean and tighten on the snug side (use 2 wrenches,...
I'd say so...You can always tighten a little more if you have a leak....-Bret ... line or other fitting that should be firm but not over-muscled? ... snug ... ...
In my experience so far, I have seen one or 2 leaks with these aluminum hose ends, always at the mocal. It could be that it is just hard to get good torque on...
Bret: Awesome job on the install and the photos! Thank you for taking the time to take the pix and share your thoughts with us; your experience will really...
I took a big adjustable wrench and put it on the body fo the Mocal, and then was able to snug it up at the fitting with a second wrench. I bet KB is right,...
