I replaced my this year with a new connector from www.bus-boys.com/ . Happy 4th! Dave ntwkdsnr@... wrote: Hi folks, During a tune up on my 2.1L, I was...
I have a used Fast forward lift kit for sale. It was installed in my van by the previous owner for about one year. However, without the dough to upgrade the...
I have an extra brand-new SA five-cylinder bell housing, complete with release bearing sleeve and cross shaft. $650. Adapts all VW-Audi five-cylinder engines...
Larry, Can't help you with the howl, must be driving you mad... but supsect the transaxle, could well be diff (I had this at low speed on a gbox about to...
Larry, I have those same symptoms. I too replaced all of the wheel bearings in an effort to eliminate the noise, without success. Then I put the van up in the...
could it be ... tires ?? I have gone through a similar routine and the only thing left I can think of. Mark J Lortie PhD Division of Nephrology and...
mark lortie
mlortie@...
Jul 2, 2004 5:04 pm
21784
Hello, I wonder if anyone has a parts car syncro in the west (I'm in Southern California). I need the **passenger side drive shaft guard**. This is the square...
In my case tires definitely play a role. The noise was much worse with a new set of 27x8.50 14 Dunlop Radial Rovers, than it is with my new set of 27x8.50 14...
OK So I'll be heading out to represent for the syncro owners once again alone. But don't worrie about me All alone with all of these jeep / exsplorer/...
anybody have the part that goes INSIDE of the fuel tank that the sender bolts to? i need one thanks matthew ===== Matthew Pollard "Racing with the wind...
This is the fixed single seat behind the driver's side, non folding. They also came in 86 & 87 1/2 campers, in either tan or blue Grey prefered, but will...
Cory, I've got 235/75-15 Yokohama Geolander AT-II's on, but I don't think that's my problem. When the tread is the problem, you can tell by how the sound...
My '91 Syncro Westy stills squeaks after new springs and shocks installed. e.g. squeaks straight-on going over speed bumps [Q] Where should I look ? -John...
Hey all, I searched the archives and didn't come up with anything. I was able to remove the front hub from the bearing with a press. The issue seems to be the...
This stuff is close: http://www.eastwoodco.com/shopping/product/detailmain.jsp?itemID=1117&itemType=PRODUCT&iProductID=1117 Tom ... is stock on the syncro?...
Hello, I have the only Syncro in my country (a 1989 Caravelle Syncro). My mechanic worked on the engine, and I think he replaced the muffler incorrectly. It's...
I am writing this for a stranded Syncro Listee. He is currently on a trip to Baja and mainland Mexico and got stuck along the way. I didn't get a chance to...
It is possible the clevis pin or yoke has worn out. Er, what I mean is that at the end of the clutch pedal, there is a hole through which a pin goes,...
I use the wax undercoating from http://www.eastwoodco.com/ . Cheers, Dave feelstranger <feelstranger@...> wrote: Does anyone here know of a source for...
Also check the ball joints. I thought my squeaking was coming from the upper control arm bushings. Replaced them...same squeak. Turned out to be my lower...
Thanks for the leads. I had forgotten that name until I read it again. Does anyone know if this is the product that VW actually used on the syncro? Probably...
I want to make sure the body shop uses the right paint for my bus. Its a 1987 Sycro Westy, light metallic blue. I think it is Dove Blue Metallic, LH5U. Here...
I found a source for used passat wheels (15x6.5 et 45 5/112mm) I haven't gotten yet enlarged the center holes to fit onto the larger syncro front grease caps...
I found a source for used passat wheels (15x6.5 et 45 5/112mm) I haven't gotten yet enlarged the center holes to fit onto the larger syncro front grease caps...
I found a source for used passat wheels (15x6.5 et 45 5/112mm) I haven't gotten yet enlarged the center holes to fit onto the larger syncro front grease caps...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
