I have a 95' Legacy Wagon with 185/17/14 tires. Someone has offered me four snow tires that are 195/65/14 - basically 10mm wider, but less than 5mm more in...
You should check the tire manufacturers web site for the suitable rim sizes for that particular tire and size. That said, yea, they will fit just fine. I have...
Like Seth, my shifter (95 Legacy) has been floppy from the day I got the car two years ago - I just thought it was normal! I too found the rusted half-spring...
At 11:21 PM 12/2/2005 +0000, dominic your nimble fingers typed... ... I just looked at an older service manual I have and it looks like there is only one...
That is pretty much how it works.....pulling gently to the right and eliminates play and buzz. Probably feels unusual because you were so used to no spring. ...
Ship 4 of the Boeing A160 Hummingbird unmanned rotorcraft program made its first test flight Wednesday from an airfield near Victorville, Calif., as Boeing...
... Sport Compact Cars covered a WRX engine swap With 24 photos (23 annotated) they said this of converting the wiring harness: "This is a big job. There isn't...
'92 Legacy, 205,000 miles, FWD - car starts easily, but as soon as I put it in drive, it stalls; starts easily again, then stalls when I put it in drive...
Hi... I have a 1998 Subaru Forester. I had to replace the head gaskets and put a new timing belt on. All the marks on the belt lined up when installed. Is...
Welcome! ... hee, my 95 Legacy has been like that for the last two years. There's a spring between the shifter rods under the car that connect the stick to ...
It's easy to have the exhaust cam out, as there are two timing marks on it that align to the other pulley, not the belt. Take a close look, and have a look at...
Im gonna go with glen on this one... I've done quite a few of these and even own a dohc myself and as your facing the motor, on the left side, i've had a few ...
When I had the exhaust cam 180 out (I think it was the exhaust, who remembers stuff anymore) after doing a timing belt change, it ran, but poorly. I don't...
Fortunately, no. I was extremely lucky. My memory fails me now, I remember it was the drivers side that was out, and I seem to remember it was the exhaust cam...
And... that soobie was going good until it met with the gaurd rail... isn't that the car your wife cleaned out about 100 yards of rail with? Ouch... I'm in the...
Thanks to all for the response.. I will check again to see that the marks line up. I will keep all posted on the progress. Again, thanks.. Josh... ... marks on...
That sucks to have done a lot of work on a car, then have it wrecked... but it happens... That car was almost a legend... the only "engine in car" head gasket...
hello oh great founts of knowledge!!! i am hardly worthy the approach, but hear my piteous plea... we have a great 1988 subaru DL wagon that needs to be...
Legend, probably not. I guess if I had a shop, and a lift, it would have been easier to do it out of the car, but since I didn't, I did what I could. That is...
another approach: When this happened to me I just rewired a bit so that if someone with the key turned the ignition key on to start the vehicle the horn would...
Hello, Wow, what a weekend. What a week! We came in 3rd overall, losing to a Porsche and a BMW. Still, for this car's first track experience and most of the...
Sweet!!! :-) ... From: Joel To: subaru-tech@yahoogroups.com Sent: Monday, December 05, 2005 8:51 PM Subject: [Subaru-Tech] Just got back from the 25-Hour...
Just a few questions. 1. Does it do the same thing in reverse? 2. Is there a check engine light? 3. Has anything been done to the car in the last couple of...
1. yes, it happens in drive & reverse - in fact, where I now park it has to be in reverse to back out of my new driveway. 2. no check engine light on 3. no...
What happens if you give it a little gas to increase the idle speed just before putting it in gear... have you tried this, and does it help... what does your...