Mike, check out www.faxonautolit.com I have been buying"license reproduced" manuals from them ... From: Mike Schmitt To: RoadRaceLincolns@yahoogroups.com Sent:...
Mike: which ones do you have? Bill. ... From: Mike Schmitt<mailto:1954lincoln@...> To:...
bill culver
bigeasy3@...
Nov 7, 2005 6:12 pm
261
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX I sell "FACTORY" manuals on cd-rom.. Not just a service manual but everything on 1 cd-rom..(I have 3...
Here is someone who contacted me outside the group? Anyone know of any Mike Mike Schmitt HYPERLINK "http://www.54lincolncapri.com"www.54lincolncapri.com _____ ...
I disconnect the end at speedometer and pull the drive cable out. If cable looks clean and there are no damaged areas to the housing, than use white grease on...
Could you walk me through this a bit? Where do I grab and do I turn, pull, pray? Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner...
I had to do this a lot when I worked for a Taxi company to keep the speedometers accurate for testing by the State and it will work the same for all cars and...
Bill: For some reason, I didn't get the reply to your original question about lubing speedometer cables. I use powdered graphite for that. You can reach up...
bill culver
bigeasy3@...
Nov 22, 2005 4:16 am
268
Thanks again. I hope I am not being a pest. I am mighty new to these(OK, so I'm not "new" anymore). Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE ...
Thank you. I am glad someone recommended the RRL to me. Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. ...
Bill: Don't forget, you can also contact our tech editor, John Grove, for tech advice. His email is dotpen@...<mailto:dotpen@...>. John is...
bill culver
bigeasy3@...
Nov 23, 2005 3:33 am
271
Folks: in regard to the speedo lube, I was always taught not to use the white grease as it will clump and become a problem in the shaft as it...
bill culver
bigeasy3@...
Nov 23, 2005 3:33 am
272
Thanks again. I don't look forward to hanging upside down but, gotta do it. Have a nice Thanksgiving. Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE ...
I was able to contact John and get him signed up to the group last week. Mike Schmitt HYPERLINK "http://www.54lincolncapri.com"www.54lincolncapri.com _____ ...
I'm sure you've done worse things in your life! Bill Culver. ... From: WZB1@...<mailto:WZB1@...> To:...
bill culver
bigeasy3@...
Nov 24, 2005 12:24 am
275
Ah did manage to burn a 56 Capri to the ground @ 16<g>. Bill PS, Have a great Thanksgiving W.Z. Baumgartner, Jr. P.E. , CHMM, REM, DEE President W.Z....
Bill: ??? You'll have to explain that one! But be careful, I might print it. Hope you have a great Thanksgiving, also. P.S. What is an "Enginee"? Bill ...
bill culver
bigeasy3@...
Nov 24, 2005 5:29 pm
277
Following is Mah contributions for "How it all began" Please feel free to share this in the mag or otherise. Also, Enginees caint spel to goood. Bill I am...
OK, I accept the fact that as an Engineer(Someone who is overeducated for our intellegence) I just can't leave things alone. My new(?) 56 premier appears to...
Dear Engineer: Probably best to email a photo..don't quite understand what you are describing. Bill. ... From: Bill B.<mailto:WZB1@...> To:...
bill culver
bigeasy3@...
Dec 5, 2005 10:48 pm
280
Engineer's first code of conduct should be... "If it ain't broke, don't fix it!" "Bill B." <WZB1@...> wrote: To: RoadRaceLincolns@yahoogroups.com From:...
2nd Law-If it ain't broke it don't have enough features on it. W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. ...
See attached. W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. Environmental Engineers and Consultants PO Box 680369 ...
The lock or latch probably got bent slightly when it was pried open. You will need to keep adjusting it back a little at a time until you get back to were it...
My problem is the "button" has never done anything. Was I supposed to push it to release? The problem appears to be in the the button. Is there a spring or...
John: I'm forwarding this email from Bill Baumgartner, who cannot figure out how to operate the ashtray on the rear of the front seat in his '56. Please send...
bill culver
bigeasy3@...
Dec 7, 2005 2:37 am
287
I've updated my website - for those of you haven't seen my '54 it is at http://home.earthlink.net/~philedmonds/ . I've also put pictures of my current project...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
