Hello Phil Sorry that I forgot about these. Between barns and hurricane clean up I forgot. Do you still have them? If you can double check the postage since ...
Hi Mike, I still have the parts for you. The shipping should be the same since I use the US Postal Service. The total would be $68.51 ($28.31 parcel post + 2 *...
I bought my '56 from an individual in Salt Lake City. Does anyone how to track the history of the car behind him? Who was the dealer? Was it a UT car always? ...
I found some info in the paperwork (non-title) that came with the car. Mike Schmitt www.54lincolncapri.com ... From: RoadRaceLincolns@yahoogroups.com ...
Hi, I'd recommend replacing it with an exact replacement 12 volt wiper motor. It bolted right in to my '54 and works great. It is available from Concours Parts...
A good coat of RainX will work wonders, and it's cheap! Phil Edmonds <philedmonds@...> wrote:Hi, I'd recommend replacing it with an exact replacement...
Unfortunately all I got was a title and car. The man I bought it from(EBay) had only just bought. I spoke to the man who owned it for about 4 years but ...
The '56 uses a combonitiation electric/vac. How do I wire up the replacement electric wiper? Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z....
Hi, I didn't see a picture attached to you last E-mail.... I'm not sure about the wiring,but the vendor should be able to either tell you or fax you the...
Try contacting bill Culver at the RRLR maybe a club member might have owned it in the past. He can put up a notice in the newsletter. Mike Schmitt HYPERLINK...
One other thing to try is get a friend that is a cop to run the vin they might be able to tell you something. _____ From: RoadRaceLincolns@yahoogroups.com ...
Sorry. Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. Environmental Engineers and Consultants PO Box 680369 1113...
Very nice looking car! Phil ... From: To: RoadRaceLincolns@yahoogroups.com Sent: 10/17/2005 6:12:21 AM Subject: Re: [RoadRaceLincolns] 1956 Lincoln Wipers ...
It needs a bit of work but it is progressing. Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. Environmental...
The have a nice write up on the 56. The even show a picture of the chassis oiler. Mike Schmitt HYPERLINK "http://www.54lincolncapri.com"www.54lincolncapri.com ...
Is this the most recent issue? Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. Environmental Engineers and...
Anyone live near South Dakata to check out a 53 convertible for sale (restoration project) in Aberdeen, South Dakota? Comes with a parts car. The parts car is...
Here is a question from a new member Mike Schmitt www.54lincolncapri.com _____ From: Johnny Covey [mailto:jpc440@...] Sent: Monday, October 24, 2005...
John look in Hemmings i think you will find a source for a wiring harness , the problem with 12 volts on a 54 linc is that the ground is positive and the 12...
MartinRP2@...
Oct 24, 2005 10:43 pm
232
Hi, I used a street rod wiring harness for my '54 and adapted the circuits I needed from it. I used one from a company called EZ Wiring. There are a few...
I finally started to clean up the rusty drive shaft for the air car and noticed that the tranny side u-joint was a little sticky. There wasn’t a grease...
Mike i am out of space , if it has the big 4barrell intake thats a good deal also it should have the Forged crank that fits the 368 . take care , Rick...
MartinRP2@...
Oct 25, 2005 2:46 am
236
Mike i still use the originals , if yours had no grease fitting it is a replacement , you should use a VICE OR ARBOR PRESS TO REPLACE AND REMOVE IT you may be...
MartinRP2@...
Oct 25, 2005 2:50 am
237
I am progressing welland should be able to bring my new baby home this week. I will post a "Status & Progress Report" later. Everything looks great but I do...
Thanks for the response about my wiring issues. I am a few months out from doing this but I am trying to prepare myself for it. I will give you a call Phil...
Johnny Covey
jpc440@...
Oct 25, 2005 1:59 pm
239
I made my own mounts but i have 2 metal breaks and other related tools , i think they make repo mounts for 56 Fords that may be similar . I am not sure what...
MartinRP2@...
Oct 25, 2005 11:20 pm
240
Thank you for the hemmings article. Was that in color or B&W? Bill W. Z. Baumgartner, Jr. P.E., CHMM, REM, DEE President W. Z. Baumgartner & Assoc., Inc. ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
