I know the feeling, allthough I have been out of the closet for years;) there is nothing but maybe the bumper that would work on mine and I was still looking...
It would only cost 400 dollars to get it here from Leesville SC. Not as bad as I thought. Puts a whole new light on it ;) wonder where I could find a motor...
Here's an engine that someone in the S.F. Bay area might find useful in their Slant Nose. http://www.craigslist.org/sby/pts/137767502.html Norm in Wisconsin ...
Curt ,thank you for the information on the EBAY front drive axle since it is a good idea to have "insurance" I am bidding on the axel I hope I never need it...
All: I checked my ride height and it is only 14 1/16" both sides. It is hard to imagine what 17" would look like. Dave; (or anyone with a '83 ish rig) Have you...
Marcus, ours measures exactly 17" but many at the Revconeer rally in Quartzsite thought it looked quite low -('78-'79 Slant.) Erin ... From: marcus pizzorno ...
HI Marcus! Well, precisely BECAUSE you are an engineer I am confident you'll want to have the straight skinny on this terminology stuff, so, here it is as I...
Marcus: I have only opinion, but won't ride height surely change as a function of overall wheel diameter? I suspect Marty's "make it level" is the better way...
Your not going to like me saying this but my ride height with stock wheels was 17.75". I told them when they did the alignment with the new larger tires to...
Out of the book "The ride height is measured from the ground to the bottom of the frame alongside the bellcrank and idler position. The correct measurement is...
Steve, The height will also efect the angle of the half shafts. I notice mine coach will vibrate some while going on a road that causes the front suspension...
Steve: As I puzzle and read, I see more pieces falling into place. Today, I noticed that my torsion bar adjusters were tightened significantly differently....
I don't know anything about where you live, but here in Indiana if you call the state police post they will connect you to a state DOT officer who will meet...
heather: Very close, but.... See comments following*** ... ***really? I agree with the site that said that the rim width is measured to the inside of the...
now that is what I call service! I'll call the CHP and see what they offer. Marcus from the state of Kallifornia with a meathead for a Govna ... === message...
I was informed by Harry at the Revconeer rally that there is that weighing service and analysis at the FMCA convention every year - he showed me the results...
Y'all are both right about the half shaft angles changing. I never thought about that and the weather was just too cold for me to lie beneath the coach (high...
Hi Steve, Thanks so much! I am going to clarify here and answer some of your qusetions on info I left out. I'm going to try putting dashes in before my...
Hi Steve, Well, with more confidence today I am re-testing all the readings. These are with the engine off, lamps plugged in. I think I have found a major...
Marcus, Whooo- man! I've thought for years about weighing individual wheels. You have simplified the problem considerably- even to KNOWING the individual wheel...
Erin wrote: I was informed by Harry at the Revconeer rally that there is that weighing service and analysis at the FMCA convention every year - he showed me...
Walt" asked Steve - do you remember where you had the CV joint rebuilt and if they are still around? Steve: I had them done here in Jacksonville Fl. The shop...
Hi again Steve, Okay, I have more readings, and today I didn't see any of the wild fluctuations on the voltmeter. To finish the readings for engine off: My...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
