All, Here is the scoop. I want to sell my white 91 Spirit R/T which is located in Columbus, OH. As I stated in an earlier post, the car has a leaky head...
Just got back from being really sick and I still have the following im looking to sell. All are from a 93 IROC R/T had 118K when cam locked up in head. Parts...
All, I took new photos today and added them to my gallery and they start at picture 15. As you can see it is a little bit dirty since it has been sitting for...
Hey, I bought that trans on ebay (srt403) a while back for $180 I think. I emailed you several times, and phoned leaving several messages, all wnet unanswered....
Hi everyone, well, I need to reach Wallace White, since the mail I have of him is not able any more, so some one knows were I can find him, any mail or...
Just want to give some positive feedback to Wilburn Rhoades III. I bought some TIII parts from him (wiring harness and computer) and they came packaged nicely...
Just want to give some positive feedback to Wilburn Rhoades III. I bought some TIII parts from him (wiring harness and computer) and they came packaged nicely...
Hey I'm just wondering. I'm not to into supping up my 92 R/T. I just want it to run great, perform around or slightly above stock and look good. So with the...
Seth, I've seen and bid on a couple of sets of "Shelby" T3 valve covers on E-bay. The final bids were sometimes MORE than the cost of a T3 car. I believe one...
I have never heard exactly what price these are going for, and never really checked into it, since I knew the price was out of my range and the fact that I...
Thanks for the replys. It was a nice Idea but I think this "upgrade" it out of my price range. But If I had the dough I think I would go with the Euro...
I think I have approx $750 into my cheapest Shelby 16V cam cover, they all go up from there in what I have paid for them. It's hard to put a value on them but...
Ok. I have been driving my R/T a lot. Well a lot compared to my lack of driving it before. Well I seem to have a coolant leak going on. I added some dye before...
One of the best tools I ever bought was the cooling system pressure tester. Pressurize the cooling system with a cold engine and anything that can leak will ...
Hello, I recently had a similar run-in on my winter car, a honda accord. I had a pinhole leak spraying. The area that was wet was no where near where the ...
Ok. Do I hooked up the Pressure tester pumped it to 10, and checked everywhere for a leak. None found so I went up to 20 and looked all over too, put my hand...
Wow sorry I missed this when I posted it. Its suposed to say: "Ok. So I hooked up the Pressure tester and pumped it to 10, and then checked everywhere for a...
put some dieelectric grease on the plug where the wires go on, it will make them easier to install and remove ... *********************************** Mark...
Perhaps your leak only occurs when the engine is at operating temperature? On Jan 1, 2008, at 4:55 PM, Mark Brooks - Rochester R/C wrote: put some dieelectric...
I did Put dieelectric grease on the tip of the plugs @ the connector when I installed them. 1 & 2 Were hard to get off but 3 & 4 Came of real easy???? Yeah...
Ok well now I'm Stumped??? I tried to find a leak with the car warm/hot! With the car running I started to let it get warm and noticed some coolan drips...
Coolant line to turbo, coolant return line, freeze plugs, head gasket? It is possible (but not easy) to remove the exhaust manifold without taking off the...
I have seen a few times that kind of mistery leak came from a leak in the headgasket at the trans side, it is hard to see, you just can find coolant in the...
Going through my stock pile of T3 parts I have discovered I have one too many sets of factory T3 Mahle pistons for the 1991/92 Spirit R/T's & 1992/93 IROC...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
