... I put a couple of those 150mA $10 cigarette light solar panels in the back dash adn hooked directly to the aux panasonic. so I'm putting in .3A at 13-14V...
... one ... iS THIS aesthetic moer than functional ? What kind of MPG increase are you seeing at 55-65 mph ? and if so, when will you implement the prototype...
Same thing happened to me...Also have a 2002 Prius, and followed the mod for the Miata battery. First battery failed. Finally got a replacement battery and...
Dale
dale.long@...
Aug 12, 2006 1:49 pm
1634
... I replaced 2001 Prius 12 v battery with an MK vented battery, which is often referred to as the "Miata battery". It would no longer hold charge after 1...
Hi Dale, Be careful of the PS (Power Steering) warning, it is intermittent and will come on more often and get worse. Did you have a vibrating steering wheel ...
Hello All. I purchased a used 2004 Prius this week to complement our 2001 Prius. I plan on adding the Prius NAV unit to this just as I have added NAV to my...
Hi. Is it possible to read the GPS data from using the CAM232 bus thingy? If so, might be able to wire it up to a laptop running Google Earth or similar.......
OK... ...what if you attach a 12 volt output solar panel to the 12 volt system in the Prius. This should effectively provide supplemental power to either...
Looking at the 2004 Prius wiring diagrams it seems that voice activation circuitry is connected to the multidisplay and not the NAV ECU. Thus, it seems like a...
First you have to actually HAVE the mic. It is located in the center roof console with the overhead lights, and the circuit board the lights attach to is...
Hello all, Does anyboidy know where the full moon wheelcovers pictured on the homepage were purchased or at least the manufacturer? Regards to all, Karl...
Jerry, I appreciate your input. Before I posted I toughly researched this and several other Prius websites. Yes, I saw the ones to which you refer, the pizza...
Nope, those won't work. I emailed that Ebay seller about them a while back, those discs use spring clips to fasten, and if they would fit the aluminum rims at...
I've actually never really seen "hubcaps" that will fit over a styled aluminum wheel. I wouldn't be surprised if those full moon hubcaps are over a set of...
OK. I purchased a NAV multidisplay off ebay. It seems the buttons around the multidisplay have their own PCB and, atleast on the NAV multidisplay, a cable...
Thanks Dave, I appreciate your help. Best regards, Karl ... From: Dave Nuzzo To: PriusMods@yahoogroups.com ; bsa65@... Sent: Monday, September 11, 2006...
No, as I noted in an earlier post, they are attached to the stock trimrings. Though I posted the info earlier, and the post does show up under Messages for...
See a picture here http://autos.groups.yahoo.com/group/PriusMods/?yguid=206367113 ... From: Dave Nuzzo To: PriusMods@yahoogroups.com Sent: Monday, September...
Is this your car and wheel covers? http://autos.groups.yahoo.com/group/PriusMods/?yguid=206367113 ... From: Tom Stangl, VFAQman To: PriusMods@yahoogroups.com ...
Hello Michael, Can you be a little more informative this? What exactly did you hear and who was the source. My local dealer just blew me off when I asked. ...
No, that's not my car. I own a silver 04 and a red 06 (the ones used for the VFAQs at vfaq.net). But I installed a set of Moon discs on my 06 right after I...
I enlarged those covers to death and could not see any evidence of screws. If possible, I would love to use them without screws. I may try urethane adhesive...
I wouldn't count on any glue holding, but you can try it, sure. Rivets work quite well, and since the discs come with 3 holes punched in them already, you...
Hello, There are sites that sell the same wheel covers with and without the screw holes. Those without the holes have metal tangs to grip a steel wheel. I have...
I was wondering if someone who has a 2004 or 2005 Prius with NAV can check the part number on their NAV ECU (under the driver's seat...). Is it 86841-50090...
That well may work, but realize that removing the spring retainer ring (spring-ring) could possibly destroy the disc in the process. You might have to Dremel...
