Any of you guys ever purchased anything from Kevin at TTR 400, http://www.ttr400.com , over seas? I am looking at adding a few of his billet pieces for my...
Ed, I have a few of his parts over at the house if you want to see some of his work. Kevin and I were working on developing the preload adjusters to fit the...
Hi All: I just found this group, and I'm looking forward to participating. I'm not actually from Ohio, but I'm building a CB350 cafe racer--which I noticea few...
Go with the tapered bearings Chris. Chris Fiaccone <chris.fiaccone@...> wrote: Hi All: I just found this group, and I'm looking forward to participating....
Hey guys, I just recently bought a '75 CB400F and I'm beginning the process of converting it into a cafe racer. I was wondering if you guys have any...
Chris - I have a 400F that I restored over last winter. I had planned to do a dual disk setup, but I ended up leaving my bike largely stock. I have a set of...
I picked up a 75 CB500 twin this fall of ebay for a cool 300 clams. It was popping and backfiring like no other out the right side exhaust and carb. But this...
Not really. when you get them and start, if you have any problems give me a shout. I have to roder some for my RD 400 project so I will be installing them...
i contacted my ppg distributor and he tells me the dau line has been discontinued for ten years.... do you have and up to date code? or is this the only one...
... we ... lay ... the ... r134 honda red. i think the ppg code is 77698 (r134 red honda code) dcx61 hardener dt885 reducer red paint - $105 a quart reducer...
... the ... but i tell ya the more i get involved the more i like it the ppl seem to be nicer and alot more helpful. i have a couple sport bikes rsv mille an...
I can second that the people involved with the cafe racer and vintage bikes are for the most part awesome. I can not wait until I get all the pieces back for...
i love my aprilia have owned 3 rs50 made to a 75cc bigbore for the wife once she got the hang of riding bought her an 96 rs 250 she loved but damn two strokes...
Hey Guys, How do I keep my clubman bars from slipping. I hit the brakes and they want to go forward. The originals were knereled(sp). It gets a little ...
Sounds like the ad was written by someone who has ESL. Hmmm "Free to run when using always change end from other. Do not make not make stop run when using....
There is only a few things that would cause it, either the clubmans are too small (OD of the bar for ID of mount), the mount has became oblonged or the mount...
What kinda of paint did you put on yours? Was it from the factory? ... wife ... but damn two strokes are to much frigin work, always something to wrench ... ...
I was thinking about sanding the mount down just a bit and use a slightly longer bolt to help them fit tighter. Do you think that would work? Troy ... me, ......
A couple of solutions, Use some type of shim, pop can tin would probably work, wrap it around the bars before installing in the clamp. It will provide more ...
