when i had my small end bushes in my rods reamed to fit my pins they did it on a machine that had an adjustable reamer spinning and the rod was kept from...
... There is a curved yoke at the front of the crankcase casting to cradle the front end of the generator. The Bosch generator has a round-headed screw which...
i shimmed my worn gen cradle works good ... From: Patrick Hayes To: Loopframe_Guzzi@yahoogroups.com Sent: Friday, June 01, 2007 2:04 AM Subject: Re:...
Yeah I went up in the Dandenongs "The Blue Mountains". Heard the mighty cry of the Kookaburra amongst the intense follage of 150'+ Ferntrees. Got to visit...
... No way! I wouldn't have said there was a chance in a billion that there was ANY way that would have been legit. It's too good already, you couldn't make...
Hi Ken, Check out these photos: "http://thisoldtractor.com/gtbender/loopframe_electrical.htm#starter_and_solenoid_repair_-bosch-" Regards, Greg Bender ... tear...
Hi All My right carburator (only) coughs air irregularly (air puffs), more so when reving up to 2000-2500RPM, is that a mixture adjusting issue, timing or...
This is exactly what happened to cause me to go tubeless, except it happened in the rain at 60 mph on a viaduct 100 ft off the ground with no pull-offs left....
Ken, I was able to make my own locating pin by modifying an M8 bolt; as I recall I dremeled a slot in the end so I could tighten it with a flat head...
Ohmigosh, that reminds me that I still have your clutch-assembly tools from a year-and-a-half ago! I'll bring them to one of the campouts. Neither a borrower...
Ok, here is what I measured on a set of drum and disc tubes. Drum length is 22 3/4 inches, splash hole (whatever it is) is 1 7/8 from the bottom of tube, top...
Patrick: It is not normal to have to bend the pipe. Are you sure you have the left one on the left side? The left pipe has a longer straight part between the...
Paul: Thanks for that. I do not use the special adapters in my bike. I use turned-down FAC dampers mated to drum-type top caps. Way beeter fork damping that...
Thank you, I will switch sides tonight and see if that fixes the problem. Patrick ... From: Greg Field <greguzzi@...> Date: Friday, June 1, 2007 8:02...
Lannis, That whole trip was the experience of a lifetime. The only thing I would have loved to have done was rent a Guzzi or some motorbike and get lost...
Al, Were you the kid who always sat in the front of the class with the really thick glasses and the pocket protector. :) Couldn't resist! Paul ... From:...
Good luck finding a rear whitewall tire in 18 inch. Most folks just buy two fronts and turn one around to use on the back. I use either the Conti Tour TK16 &...
A 2.15 rim is designed to properly use a max tire width of 4.00-18, 110/90/18. a 120 is difficult to install and will not use its full tread patch because the...
As I am sure you have all noticed there are many nice Loops on Ebay. I have never seen so many nice ones on all at the same time, seven to be exact. I ...
I have a 1969 Ambassador. Recently I began having starting problems. Had the $25 AutoCraft battery (300 cca) , that is 2 years old, load tested. It tested...
Hello. The belt appears to be snug but not too tight. It is a smooth belt not toothed. There is some black dust in there but not much. I noticed 4 shims on the...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
