IMO probably easiest to refabricate it in tubing rather than hose. But, if you want hose, you can get corrugated stainless that's good to around 1500F in sizes...
Mike, The EGR line has to be all metal. Corrugated stainless is airtight, spiral wound stainless tubing is not. Make sure you know the difference. A hard line...
EGR does the lower tube have to be metal? Mike, Can you fabricate up something from copper tubing? SS is probably overkill for this application. Rubber hose...
Cu would be my choice (if I were Mike) as well, a bit soft but there are a couple of distinct advantages: a) Compression fitting (like the stock tube) or...
Brazing will work fine. Use SiL-Phos 1710. Can the original be repaired or is it toast? Craig ... __________________________________________________ Do You...
Okay, I see what you are doing. Why not forget brazing and use flare or compression fittings? At the manifold use a 1/8 NTP to 5/8"(or 12mm) flare or ...
Ooops! 5/8" should be 7/16" Craig ... __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam...
Because I have changed my mind and am doing some different things, I have a couple of body parts available if anyone needs then. *Scorpion original noseband....
Mike, As I recall, I tapped the Monte exhaust manifold heat shield boss with a 1/4 NPT because the boss is not large enough to allow a larger size. I installed...
Oh yea, I also posted a couple of photos of my slight of hand trick for creating a Monte down pipe exhaust manifold gasket from a Fiat DOHC gasket. This gasket...
... You should the Lancia novel on the Beta ... __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam...
Will, My goal was to integrate the more efficient Monte 4 to 2 to 1 exhaust with a EGR setup for passing emissions and better performance. I wanted reliabilty...
I understand what you did, Tom- I was just saying that I took the other route and simply welded the header and downpipe together on the Zagato- it eliminates...
James: Thanks for all the information to date. (I'm cc'ing you and Val directly). It appears the big starter you have is the Marelli (cast iron nose job). That...
... silicone ... Hi Will, Are these Vitaloni mirrors are supposed to have a "universal" style mount? Are new mounting holes needed to be re-drilled? These...
Vitaloni Californians have 65mm mounting holes- the Baby Turbo and/or Baby Bravo mounts on the same holes with no redrilling, and can also be adjusted ...
... his ... That's correct. However, all the new Californians available in recent times have a slightly different mounting pattern. DJ -- No virus found in...
The Vitaloni "Baby" Turbo, Bravo, Tornado, etc. have slotted mounts. The idea is that you can mount them on the original screws for aftermarket applications....
Will, can you tell from this picture where the original vitaloni(s) went? That's the trouble with having a car that has been through a lot of owners, you get...
Different spacing. DJ _____ From: LanciaScorpion@yahoogroups.com [mailto:LanciaScorpion@yahoogroups.com] On Behalf Of Will Holding Sent: Sunday, March 05, 2006...
planning to replace slave cylinder anyway, just because it's about time (again). Looks like it just moved up on the priority list..... Symptoms were a clutch...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
