Hello to all. I am wondering if anybody can point me in the diection of a second hand front brake master cylinder body? First looking for an original body for...
... of a second hand front brake master cylinder body? First looking for an original body for 1981 A2 Z1300. If all fails then i will have to look at changing...
Hey!! I have one, which will need to be rebuild, because this bike has been seating for at least 18 years-since 1991-judging by the registration.... 7000 +...
Hey Nickola Many thanks for your assistance and I will take your master cylinder as per email details. To all who gave advice many thanks and problem solved...
Does anyone have experience with Dyna Coil 3ohm coils? I have only seen postings referring to the Nology and Accel coils. There is a set on ebay that claim to...
... seen postings referring to the Nology and Accel coils. There is a set on ebay that claim to be an exact replacement for the stock coils. It didn't give a...
... seen postings referring to the Nology and Accel coils. There is a set on ebay that claim to be an exact replacement for the stock coils. It didn't give a...
Hey folks can anyone tell me what rpm there at when going about 70mph. I'm at 4000 give or take. I have a 1980 with 7000 miles. It seems to me the rpm's are a...
Hi all: I recently purchased a ZN deep sump oil pan and I need your help on what type of exhaust headers I can use. Will a six into one work with this pan?...
Hi friends!! please see the attached picture. 1st. do you think that the plastic gear is in good condition?? I changed 15.000 miles ago, how long shold it...
Hey Bob, Just checked my A2 on the way home from work with the GPS, and at 4000rpm, I was doing 64-65mph. Referring to the manual, the performace curves at...
Great news! I've received my first set of bearings and will be ready for orders. These are the only bearings for the 1300's in the world as it is discontinued...
Bob, hello!! I have 2 running bikes 1980----shows about 70-72mph @ 4000 rpm 1982----shows 70 mph @ 4000 rpm---steady So---I do NOT think that rpm`s are too...
Hi all, Well the restoration is going well but slowly due to funds but there is a part I'm trying to hunt down without to much luck so I'm hoping that someone...
According to the Service Manual the correct plug for the US Model is BP6ES the Candian and European Models used the BPR6ES. The Manual also refers to a W20EP-U...
Do I have to take off both mufflers, like the manual reads? Or can I just undo the botton shock nuts and lift the wheel up above the muffler. Any tricks or...
Alan: Â If I remember when I took my rear wheel out, which does come out very easily, you need to remove at least one muffler to withdraw the rear axle...
... I always drop the shocks at the lower end so I can move the swing arm up or down enough to withdraw the axle. Beats taking the muffler(s) off. Brian...
This one is off topic but, it seems like I have seen some interest in side cars on this board so I thought I would share something another vintage bike rider...
After a two hour ride, and parking it outside my garage to cool down, I noticed a small pool of oil about the size of a pie plate. This was dripping off the...
Sounds like a bit of oil, Tim. There usually is a breather hose going from the engine to the lower air cleaner case, left side, under the carbs. Take your air...
I'd like to comment on removing a rear wheel because a couple of people have asked me about this in the last couple of days. The mufflers don't have to be...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
