I got all four lines (front & back) from Penn Ohio Sports (you can google them) the cost was about 150.00. ... From: suz_re5a <W_Vance_Stanley@...> ...
Thats about what I paid for the stainless lines from Hel I think. I can't remember for sure. I do remember that I had to make sure that the measurements were...
I'm going to do the valve clearances on my ZG1300 this Winter & I remember someone mentioning in the distant past about setting them on the 'loose' side so...
Phil, Just so you'll know, the KZ1300 message board is not defunct by any means. I incorporated everything that was on the old KZ1300 message board into my...
It's come to my attention that there are 3 different starter clutch numbers for 1300 motors! 13193-1004 only shows fitment for 79', 80' & 81' Z1300 or KZ1300....
I just blocked a post by Bruce and sent the following message to him.: "Hi Bruce, The group has decided that your first amendment rights follow from your...
You have my vote Bill!! regards, Horacio P Antes de imprimir este email piense bien si es realmente necesario. Before printing this email, assess if it is...
I have to agree with Larry on this. Sometimes there is a temptation to run the valve clearance on the tight side thinking that you might, and I emphasize...
Works for me. Tom ________________________________ From: kzcsi <kzcsi@...> To: KawaSixes@yahoogroups.com Sent: Mon, October 26, 2009 7:40:52 PM Subject:...
Well done Bill you have handled that well. I agree with the bit of lattitude to other motorcycling issues and other sixes while at the same time the priority...
Hi Folks, Well, we lost KingMobely and IronBoltBruce. I'm sorry about KingMobely, but couldn't care less about Bruce's decision. I see that we've exceeded our...
I agree as well. I didn't read any of those posts so no loss. I do agree with a sliding scale as some of the posts are by regulars who do post useful and...
ditto on the valve issue. My thought is run them on the lower side and when they do wear the will have a couple of thousanths additonal before they need to...
Hi Tom, This clutch cover is excelent, I can check the oil level even even sitting on the bike and looking down. I dont know if it's compatible, we should ask...
KZ1300 covers do NOT interchange with ZN1300 covers! There are so many differences between KZ & ZN motors I made a list somewhere on my site, maybe on the FAQ...
OK, here's the link I left out to my previous post on this rear master cylinder for a Z1300 - http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=260497817658 ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
