Just thought I would post again that I am looking for a Duke ll. I am aware that there are Dukes on ebay, but I prefer a straight seller/buyer transaction. If...
Brian, Thanks for the info below. It saved me $500 on a new carb. My bike was sputtering and sometimes dying after engine braking and then cracking the...
Sorry, I should have given more info. -2000 Duke (California) -Mikuni carb -mesh air box cover -EPS removed -Y-pipe (I am not sure if this is stock or...
might be willing to sell my duke2 8700 miles perfect always garaged adult owned never down never ridden in the rain new chain sprockets brakes air cleaner nice...
So it's 90F+ aproaching 100 in washington, DC. I road the other day 75 to 80 blocks in stop and go traffic about 40 minutes. Towards the end, the bike was...
Interesting solution. Hadn't thought of it. Doing a search for LC4's and cooling I've seen several posts one on advrider about adding a second fan... Rob...
OK: let me throw this out. I might be willing to sell my 2000 Duke2. It is green, has less than 3k miles (I have several bikes) Never dropped, garaged,...
... 145 main jet, here in california I've got a 170. Also raised the needle here a couple grooves to richen the mid-range. I have the FCR41 but this should...
Been thinking about doing it for a few weeks now but I figure I should go ahead and post it up before I changed my mind :) 2002 KTM Duke II - 4600 miles. Dual...
What if the reason for drilling the Carb slide? Am i right in thinking that drilling the outer 2 holes, not the one in the middle, to 3mm is correct? And...
I know the subject has been covered before, but I was viewing the photos on this site and saw Duke II with a carbon fibre rear hugger. Where do I get one and...
Guys this bike is the BEST bike Ive ever ridden..........in terms of handling, braking, engine performance, no other bike comes close....... yes, its not...
You can go in for the Barnett or DP clutch plates. You can buy the friction
plates, pressure plates and springs separately or as a set. No idea
regarding the...
This site is useful! http://www.teamincomplete.com/Projects/Duke/dukeiiintro.html <http://www.teamincomplete.com/Projects/Duke/dukeiiintro.html> Jon _____ ...
thanks Jon but I couldnt find any info about removing the emissions control (disconnecting microswitch ) ??? surely some here must have disconnected it by...
I'm not sure about the reason behind drilling the holes. My slide was already drilled to 3.12 mm so I never asked myself this question. You are correct it is...
thanks Nik usefull, I know where to look now but surely someone has a photo of it ? seems to be, that very little is mentioned about this EPS system, yet its...
I have the plastic version and I’ve never installed it; I’ll sell it if you are interested. The carbon one you have to get from Germany. There is a little...
... thanks Bill actually, I wanted to just disconnect the electrical part of it, and leave the rest alone..... in fact, I was looking at the carb earlier,...
Andy, I am not that familiar with the emission controls. My approach was to try and document what was previously done to my bike. I have empty 2 pin connector...
Drilling the two outer holes to 3.2 mm (or 3 mm if you can't get the 3.2 mm drillbit) will cause greater vacuum effect which in turn will raise the slide...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
