Not sure if its the same thing you are mentioning but the rubber seal at the top of my screen is only just on the screen itself. If I put my hood on (which is...
Yes Simon, not enough of the seal is attached to the top edge. I had to slacken off the tension of the new hood I had made a few years back because of the same...
Hi Alan, Sorry not to have been in touch before this. My G33 runs Dellortos and I use a filter supplied by Macdonald Racing. I can give you all the details if...
Dibble
dibble1@...
Oct 3, 2008 4:40 pm
1863
Dave, thanks for your input. Being a northern lad, I have known about Macdonald racing for many years, although never had any direct dealings with them, they...
Dave, should have thought of it earlier, if you or anyone else want to see some pics of my car, including a shot of the carbs/filters although the detail is...
... about ... ago ... located ... keen ... arrangement ... clue ... bonnet ... Reason ... removed ... the ... an ... pictures. ... so ... parts. ... my ... ...
I think I am right in saying that the rear lights are off a Chevette ?? Is this right ?? There is also a black plastic surround but I wouldn't have thought...
The lights are indeed off a chevette, but do need modifying to fit the G33. The chevette lenses have a plastic rim which has to be carefully cut off using a...
I have the set I removed from my car when I put circular lights in. As Nick says they are "modified" in so much as they are ground down to fit. Want to make me...
Thanks for the offer. The actual lenses themselves are fine, there is just a hard black plastic surround which finishes it off a bit better that is partly...
I've added a photo in my photo file on the yahoo group, not that good but I think you'll see what I mean. It was covered in black plastic tape for years but I...
My car won't start !! Started last Sunday after having not been started for 2/3 weeks no problem. When a prospective purchaser took a look today she wouldn't...
To add some more info - i pulled a couple of plugs out and they stank of petrol so theres obviously petrol getting up front. With one of the leads off I got...
Kill Switch definately cuts the fuel pump, so you wont hear it prime. Not sure what it might be though, i assume you have fuel in the tank? It may be an ecu...
These engines can flood pretty easily if they dont start straight away, as the ECU puts in far to much fuel. Id drop all 8 plugs out, and pop them in a low...
Could it be the classic condensation in distributor cap problem? Have you had the cap off and cleaned the inside up with a little WD40 and checked the contact...
Didn't know of the 'classic condensation in the distributor cap problem' but its now on the list of things to check tomorrow !! Plugs are out and warming in...
Having had a good look at the diff mountings, heres my particular solution to the problem of the rear brackets failing. As you can see from photo 2653, there...
Having had a potential buyer around for my car I soon found out that the old girl wouldn't start !! It started last sunday no problem having not been driven...
I thought I had sent this !! This was an earlier email than the one I sent yesterday !! I thought with the clocks going back I had lost a moment of my life. ...
An additional thoyght. Check the lv supply to the coil, and then see if you can get a spark from the king lead by holding it close to the block. But only...
The "kill switch" just breaks the circuit to the fuel pump as you suspected, so if the fuel pump is running it's not that. Have you checked the usual suspects:...
Bought some new plugs and a new coil and it fired up first time. Shame it didn't when my prospective purchaser was there !! Hadn't heard of the condensation in...
Mark First an update. The red V8 G33 with the TVR 5L lump (ex Paul Edwards) now belongs to Rob. I have sold my half share in the car to allow me to ...
Picture 2 Graham International Power plc, registered in England with number 2366963. Registered office Senator House, 85 Queen Victoria Street, London EC4V...
Picture 3. The piece across the top of the diff has to be removable to allow the diff to be removed/replaced - something I'll have to get used to if this...
Dont say I didn't warn anybody ! Especially you Graham as you use your car for competition. If you solid mount, you will break the diff housing; Even using...
Dont see a problem myself, I always thought the G33 chassis itself came under the catagory of flexable at best of times !! More to the point I just managed to...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
