Someone PLEASE GO BUY THIS THING ... it's awesome and needs a home on YOUR rig. I'd nab it all the way from Michigan, but just bought a DozerII rear swingout...
Hi everyone, This one's mine, this time! I’m selling a new billet roller cam, by American custom cams. Was originally ground for a 401. .651” Intake...
I discovered a couple reasons why my current Chev was rough running and eating so much gas. The power wire for the choke was loose. Yesterday the truck...
This is the Full Size Jeep Mailing List (FSJ-List), of the International Full Size Jeep Association (http://www.ifsja.org). Its purpose and direction is for...
FSJ-List@yahoogroups....
Jul 1, 2008 8:02 pm
92629
I want to swap the starter solenoid/relay that is on the passenger side inner fender for the Ford design. Does anyone have a diagram on how to wire in the...
You would need to swap out starters. Your starter has the solenoid on the starter that is triggered by the green wire that follows the heavy positive cable. It...
Don Weber
tuba_umphblat@...
Jul 1, 2008 11:44 pm
92631
I will have to look more tomorrow. It has the stock solenoid on the fender but a Dodge Cummins starter. Keeping Your Memories Alive while Creating Family...
Where do you live? This could be vapor lock. When the tank is less then half full, there is less thermal mass in the tank to resist the ambient temperatures....
The disclaimer has the distinctive tone of the voice of experience. Space does not permit me to give a comprehensive list of my learned- the- hard- way tips. ...
That is somewhere in the neighborhood of 3 mpg, assuming a 20 gallon tank. It seems like there would be somthing REAL obvious in a case that extreme, like a...
Is the tank vented properly? A tank with no venting will feed gas OK until removal of fuel by the fuel pump creates enough vacuum in the tank that fuel will no...
I am not sure it applies to FSJ's, but I had a 55 Chevy that did the same thing. It went through gas at record rates. Gas was $0.29 a gallon at the time, but...
Yes that is a good thing to look for. One of mine had a leaking diaphragm and was diluting the oil. Luckily I noticed the diluted oil before it caused a...
That and the difficulty of changing the mechanical pump makes a pretty strong case for going electric. Dean Keeping Your Memories Alive while Creating Family...
Do you have the part number? Can you read the terminals? S is for start. I for ignition (12VDC pickup for cranking) If the third small terminal is on the back,...
i have gone electrical and will never go back to mechanical. when i hit the key it primes the carb and it runs at 1.5 to 3 psi so the flooding off road is...
I have been thinking about going electrical on mine as well. I am pretty sure that the pump is not working correctly. Any recommendations on which electric...
I have been thinking on this and it seems Don would be correct going the other way as the stock relay would be way too light for the starter but going this way...
I did a lot of searching and reading and this is the one i choose. I have been running it for almost 3 years and not a moments problems and its fairly quite. ...
Are you running the pump through the old mechanical one, or did you remove it and blank off the hole? I assume the electric one is mounted near the tank? ...
Yes Dave, the Golf hybrid is nice , but they should get better fuel economy. Peugeot has been building small non hybrid diesels for years that get down to 3.6...
Hi Greg , I have a stage 3 shift kit in my Cherokee and most of the time I shift it as a full manual, it is pretty harsh in the shifts and really bangs into...
Some people pull over 60 mpg with their current VW TDIs in the USA, but they really drive conservatively. lol So I do believe that the Golf hybrid could or...
Matt , I think that everyone is on the right track and that you need to look for a leak rather than excessive usage by the engine (I'd still check the fuel...
i removed a 258 and replaced it with a 4.0 so i didn't have to make that choice. but a Chevy block off plate is suppose to fit the AMC motors, i would not go...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
