Maybe they are not cast. How can I tell the difference between cast and steel? Dean ... From: Jackie Garrett To: FSJ-List@yahoogroups.com Sent: Saturday, May...
You aren't supposed to bend them, BUT I have used a oxy-acet torch to heat a few up (just past cherry red) and bend them, then use a carburizing flame and oil...
Thicker bearings (to fit a smaller crank from wear/machining) make it tighter. I was fooled (and I AM an AMC guy!) by a cracked oil pressure sending unit...
Around here and many other states it's illegal to even go off highway without a spark trap in summer time. Jim Blair, Lynnwood, WA '87 Comanche, '83 Jeep J10,...
Another possibility is the back of the valve cover leaking (running into the bellhousing where it can't be seen behind the head) or the cam plug (freeze plug...
It may be just a rumour, but apparently the last few years of 4.0L went to a 1 piece rear seal. Having a clean functioning PCV system keeps the rear seal from...
Ah the cost of learning. Been there but luckily I did not install backwards. ;-) I think I stripped some of the upper seal when I installed the first one. ...
Good point, what constitutes an authorized spark trap? I have been anticipating taking the muffler off the Wag with the 4BT and just dumping to the side in...
AHHHH, the groups in the subject line???? ... From: Christopher Wilson To: FSJ-List@yahoogroups.com Sent: Sunday, June 01, 2008 11:32 AM Subject: Re:...
Still have no idea what you're talking about. Tellico is a Offroad park not a group. What am I missing? ... [Non-text portions of this message have been...
they are just local clubs from the greater Charleston SC area. some are jeeps only and some are not so picky and they are the most fun because of all the brand...
It amazes me that some guys only seem to read PART of a response and then respond to a response that never existed. Then the whole thread goes another...
Good point. I learned to loosen all my belts (alt, pwr steering, A/C) and that helped a lot. The upper seal goes in easily with the belts loose; same for...
Thanks, that is way toooo far away from me. I was hoping they were groups that do off road adventure trips. It was a stretch but the comment about "tail...
This is the Full Size Jeep Mailing List (FSJ-List), of the International Full Size Jeep Association (http://www.ifsja.org). Its purpose and direction is for...
FSJ-List@yahoogroups....
Jun 1, 2008 8:22 pm
92245
Dean: Your clutch and brake arms are cast, but they are cast steel and not cast iron. Carbon content is the difference. Cast steel is much more malleable than...
I have a '74 Cherokee I am parting out since I can't sell the whole thing. It has a 360 2v, TH400, BW 1305, Dana 44s, etc. Everything works fine. Let me know...
I hear you Jesse, I have seen the aircooled VW engines leak out of their front crank seal when there is too much movement in the crank fore and aft. If the...
AHH, thanks. I was surprised it was cast "iron". This is encouraging. Dean ... From: Paul Stuevens To: FSJ-List@yahoogroups.com Sent: Sunday, June 01, 2008...
not mine ... http://nashville.craigslist.org/pts/702102501.html Sincerely, Greg Taylor :) <>< And the testimony is this, that God has given us eternal...
Well, I all I have on installing my front axle is hooking up the steering, then I will move on to the rear axle. I was thinking about wanting a little more...
Matthew, I am in Birmingham and have a home in Montgomery. Can you email me directly (markjackson@...) or call me @ 334 546 1371 to discuss? I am ...
Mark Jackson
markjackson@...
Jun 2, 2008 1:51 am
92254
At least with a FSJ, you have room to carry around a step ladder. ;) With 8" of lift, a three inch body lift won't look goofy. It may not be all that...
Don Weber
tuba_umphblat@...
Jun 2, 2008 2:37 am
92255
Got it, thanks Greg. This was only about 5 miles from me. The engine stand was the $50 part. I'll catalog these parts into my vast inventory and make 'em...
I used Permatex RTV, but it wasn't #2. ... From: dave To: FSJ-List@yahoogroups.com Sent: Sunday, June 01, 2008 6:30 PM Subject: Re: [FSJ-List] 258 oil leak Do...
Are you tall enough to reach in and get the tailgate open? ... From: Carlton J. Patterson To: FSJ-List@yahoogroups.com Sent: Sunday, June 01, 2008 7:14 PM ...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
