My cable froze up and I broke my bellcrank just after coming out of he mountains in Wy. I was west of Laramie on two lane 130 and about 40 miles fom I-80. A...
Thank you Jim. That story of yours make me feel a little less quilty for driving on your roads with the poor handling #477. I will ask a traffic-officer how...
The agitator strikes again!! ... From: Jim Evans To: FMCMotorCoach@yahoogroups.com Sent: Saturday, February 03, 2007 7:17 PM Subject: [FMCMotorCoach] WACKY,...
I've posted a picture of the axle shafts on Borrmann FMC 645 on FMC 2. These are the axles used to install a Rockwell RS15120 diff into a FMC differential...
Yes, I have an interest. I plan on investigating the various options for reducing the gear ratio of the rear end on my coach. I will be staying with the gas,...
Stephen - We have sold some of the gas engine FMC Coaches a 4.10 ratio differential with 19.5 tires. They reported good driveability. I would say not to go...
i had a 4.11( with 19.5 wheels) in mine with the gas motor it was fine from a start the only weak spot was at about 45 to 50mph it laged a little i ...
Since I probably won’t do a conversion to a front radiator for some time, a change in gearing would reduce the rpm and, along with it, the level of fan ...
Is the Cruise Control system used on the FMC special in any way? Mine is not working and I am looking to either repair or replace it. Thanks, Ron #621...
Hey Ronny Pooh! Don't feel bad....mine doesn't work either, it did for a month or so....then it went kaput!!! so now I just use a brick and some duct ...
Stephen, etsl - the 4.11 ratio with 19.5 tires will run about 2700 RPM true at 60 mph until you climb steep grades. Your ALLISON Trans. will be good as I could...
Ron - On the original cruise you need to check - Vacuum Lines to Servo. Be sure that vacuum will pull down the Servo. If the Servo is Leaking we have new ones...
I think they are just plain old Do0dge systems, not a problem find parts. Steve #622 Phoenix Ron Herbert <rsahii@...> wrote: Is the Cruise Control system...
Ron, My original cruise control stopped working and I had a rebuilt unit installed and all was well. Subsequently I converted to the Allison trans and then my...
Stephen, etal - The transmission pencil gear pickup for the Allison was first with a brass gear and then a steel gear. You need the steel gear as the brass...
I will have to install Jamie's cruse control on my unit as it did not originally come with cruise control. Or maybe Stephen's unit would be a better option....
Leslie, It was the steel gear that made it the 200 miles. The brass ones lasted from 15-50 miles. Stephen Heinrichs ... From: FMCMotorCoach@yahoogroups.com...
On my #708, I am having trouble finding the drain for the fresh water system. I would like to drain out the water and start fresh. I am told the drain is...
Mine is accessed from the right side. It is behind the right front wheel a couple of feet and inboard about 3 ft. Just an exposed valve sticking straight...
Thanks, Stephen. Based on your description, I think I found it. Mine seems to be under the rear dinette seat, in about 3 feet. There was nothing sticking...
You got it! Stephen Heinrichs ... From: FMCMotorCoach@yahoogroups.com [mailto:FMCMotorCoach@yahoogroups.com] On Behalf Of gregoryrmiller Sent: Friday, February...
The water tank drain locations depend on whether you have an A Model, a J Model,a M Model, or a Club Coach - plus the later coaches (#0646-#1050) can be...
You, your family and coaches are all invited to the GLASS ( Great Lakes Area Spring Spree) rally in a wonderful part of southwestern Michigan (Berrien Springs)...
DITTO for 536 ... From: fmcclub@... To: FMCMotorCoach@yahoogroups.com Sent: Tuesday, February 13, 2007 10:19 AM Subject: Re: [FMCMotorCoach] Great Lakes...
Having problems with message search?
Fill out this form to ensure your group is one of the first to be migrated to the new message search system.
