Don't think there is space for this jc ... From: "randy" <bluenose4u@...> To: <FMCMotorCoach@yahoogroups.com> Sent: Sunday, May 02, 2004 10:02 PM Subject:...
There isn't enough room. These are actually fairly common, although I haven't heard of this brand before. Serve the same purpose as a transmission retarder....
These magnetic brakes as I understand are large, heavy, expensive units. The drive shaft must be of sufficient length to accomodate it's size. For a motorhome...
FYI, We're traveling in #110 from Colorado Springs to Santa Cruz in early June. West bound, we're going thru AZ (Petrified Forest and then Lake Havasu), to...
Jim, On the Santa Cruz to Lake Tahoe leg you will pass within two miles of my house and 'ol number 1046! Here is a tentative plan given the limited parking...
You will really enjoy Dinosaur NM. It is a very beautifull place. The last time I was there it was for a couple of hours and we spent about 3 days there and...
i have a 1975 fmc bus conversion for sale, was beer bus for the frontier saloon in ft. collins co. converted 1988-1990, later updated to newer drive train....
i can take some pics but i will be out of town till the end of next week so it will probably be next thursday untill i can send them to you. i will be happy to...
send me your email address and i will send you photos next week. sorry it can't be sooner but i will be out of town for several days. steve boatelcal@... ...
4" original equipment waste gate cap. Contact vintagethunder@... Our normal FMC parts sources do not have, advised to look for used one. Thanks, Udo...
4" original equipment waste gate cap. Contact vintagethunder@... Our normal FMC parts sources do not have, advised to look for used one. Thanks, Udo...
This was the fun part of owning an FMC,Udo. jc ... From: "Udo Horn" <vintagethunder@...> To: <FMCMotorCoach@yahoogroups.com> Sent: Friday, May 14, 2004...
Udo, Check GMC and Superior as well as Clark Cortez sites.Also a site called Classic RVs. Don't overlook Arizona RV Salvage,but doubtful.Don't know for sure if...
Just had a lot of trouble getting nuts off that were put on by a "roadie". Could anyone tell me what torque we are to use on 19.5 alum wheels? thank you, Harry...
425 ft./lbs.....seriously? That seems really high. Not sure on the Alcoa wheels, the original FMC wheel spec was 300-350, and I thought that was really high. I...
As you know a regular Chrysler 440 pump will not work.They don't even look alike. Can your old one be rebuild? I had mine rebuild in Phoenix AZ. Only place...
As you know a regular Chrysler 440 pump will not work.They don't even look alike. Can your old one be rebuild? I had mine rebuild in Phoenix AZ. Only place...
Make sure you are turning the right way the budd nuts that go on with the 19.5 alcoas have right hand and left hand threads they will have a L stamped on...
