Frank, I know the response to your questions has been slow but I've been slower getting my tranny back in.<br>1. I keep it above 2500 R.P.M. I put 3600 miles...
Does anyone know when the "Investor Model" bikes were built? These are bikes with serial numbers below 0000100 but I know they weren't the first ones built...
The 'Investor Bikes' were inserted into the build list before the 600's and were finished in the mid 700's. These bikes were also numbered into the 130's and ...
As of last week I sent payment to the maker for our order. I thought I would have another week or two to give him my final count. As it turned out this is not...
8I got off the phone with Osprey, they will exchange the original bags they sent me then replace the bags with a oair that have flat backings on them. the ...
I got a set of Saddlebags for Christmas, and they are the standard drape over the fender type. For under $10.00 I made a set of brackets to support the bags,...
Happy New Year to all! We have our first meeting of the new year scheduled for Saturday, January 19th. This meeting will be held at the company I work for, The...
Minor brain fart. John Jones, not Johnson will be working with Shawn Bailey. <br>A further note: Waz will be bringing rally posters for both years, bandanas, ...
Gee, Mr C, I'm a begging you guys to see if you can work the topic of Club patches into the agenda. I've got a bad patch jones.<br><br>Wish I could make...
This probably was discussed on a previous post, but since I don't know how to find it, I'll ask... I just unwrapped my new X and the battery in the crate is...
I've been keeping a file of some of the more relevant posts categorized to address some of the problems such as yours. If you'd like me to send it to you let ...
There's a picture in the photos section under Battery Tender Install. Take a look at that and see if you can make out enough detail to help. If not, I think...
#1360 and I went for a good NewYearsDay ride, but we had the benefit of it being 36 degrees. A relative paradise by comparison. Of course, since we were out...
The pic's show where the negative terminal attaches, but my problem is getting the positive terminal hooked up in the tight space available. The rubber boot ...
The wires are attached to the top of both terminals. It`s tight, but you should be able to get it. Take the seat off too. You may find it easier to get a ...
My '+' was attached on the side but the '-' was on top. This was probably at the whim of whoever PDI'd the each bike. It doesn't seem to cause a problem either...
The cable is too stiff. You can get it oriented right with the seat off using a screw driver. Keep it as straight back as possible. On another note, we are...
Thanks to everyone for the input on the battery cable problem... I'll try a couple more times and let y'all know how it goes. Hopefully, I get this X fired up...
My fix was to grind a 5/16 half moon on the box,<br>and cut a grommet in half and epoxy along the edge. The lip of the box impedes the cable from<br>sitting ...
hey russ try terry cables from dennis kirk they are so plyable you can tie them in knots!!! try terry cables dot com. they come in different lengths. dave x851...
Yeah, I know about Terry cables and they are first class all the way. Problem is they are very expensive. A set of three for pos, neg, and starter for early...
Thanks for everyone's input on the board and off on the battery install. With some perserverence, it went in and doesn't appear to rub anything. <br>Thanks...
I wanted to pass on some information on an area to watch closely when replacing the clutch slave cylinder. After installing the X-man assembly, it took me ...
