Message to Steve Stavos, Do you still have any ignition switches? In going over old messages I see that you had redesigned them. I have EH#1771 and am trying...
I am a new member and I'm not sure if this is the best place to ask these questions or not. If anyone has a suggestion of a better place to ask this, please...
Contact John Parham owner of J&P Cycle Catalog Company, Anamosa, IA. He has worked on several for his museum and sale. Better to write to him personally and...
Anybody know what might be the cause of the bike squealing when accelerating? Seesm to work fine upon starting but then after riding for a while bike starts...
Squealing is such a subjective term. It seems doubtful to me that it is a loose belt causing that kind of sound since it is a cogged belt and you would likely...
We all run the drive belt loose, but too loose will cause a chirping sound. It took me a long time to figure out just what the hell was going on. Dale 861 ...
Check the belt on the rear wheel sprocket and see that it is tracking straight. It could be rubbing on the inside or outside. Keith #952 & #1698 _____ From:...
Well Thank god i do not have to go though the pains that the other gentleman has went through. But the past owner as stated on the title is Cleveland Cycle and...
I have Deadwood 1702 with 9050 miles on her and still love to watch the HD guys look her over. I have had almost all upgrades done but I did just have the...
Get the Stavos kit, you will end up throwing away the butterfly knob you just bought, but at least you probably won't loose the tumbler. Here is some info. ...
... knob you ... Here is ... Behalf Of ... the ... did ... and ... has ... just ... months before they have the new one's completed at least there is a fix. ...
Has anyone heard from Mike McGinnis? I've been trying to get a hold of him since June but no luck. I had to send my backrest back to him in September after it...
Does anyone know what the appropriate labor (hours) should be to install the rear drive belt on a Super X, without any other work being done? I just got...
I took it to Twin Specialties in Raleigh, NC. I couldn't find anyone else that would work on it. They thought it would be about an hour labor when they...
Well, For those who know Berlin Bob, I will tell you the news. Bob hit a deer on his G/O X about 9 pm last night. Thie X had some broken spokes on the front...
The swing cage pivot bolt has to be removed, so yea, depending on the problems getting the bolt out -- and sometimes that can be a bitch -- it could take some...
Not completely surprising to hear it took that long for an inexperienced shop. I am a little concerned that your shop also does not understand that your belt...
Thanks for looking out...I actually printed off the adjustment instructions from Bobby Baldwin's website and brought them in with me when I dropped it off...so...
I recomend getting a set of tools and getting the phone numbers of a few folks on here and doing it your self. Last year I was researching puting a wider tire...
Seems the switch that controls the N light on my dash isnt working. Can anyone give some insight as to where I might start looking to fix this? DanM...
this happened to me several times. check the wire on your right side just after the engine, just infront of the tailpipe. this comes loose and doesnt show a...
In changing the CPS, exactly what needs to be disconnected? There appears to be a small metal clip holding the sensor. I do not want to mess anything up, so in...
Where can I get a parts manual? I already wrote to some of the folks on this board and have not received a reply. Maybe everyone was at Sturgis. Super X...
