To all who may have read this article from the message but not bothered to open up the "water injection table"---do so and scroll to the 27 brief statements...
<I would really like to pick up a set of highway bars for Deadwood #1724, preferably in black to match the rest of the scoot, but i have never seen any that...
<Only one response to my question on where to hook up the trailer wiring. Am I the only one with a trailer hitch? Isolator system? Where do you tie in? etc.? >...
<With so many of these stator failures occurring I think that, along with the infamous lifter problem, we may have to consider these shunt regulators the next...
Carefully check the wires going to the coils. Mine were stripped improperly and had bare spots that were grounding on the cam covers. -bj Please note: message...
... A New Hampshire X'er owns #1563 with the side car. His name is Mark Richardson. Maybe he could give you some insight. mailto:mrich862@... Mike Moody ...
See if you can get with Daniel Murray of NC about the trailer hitch. He has sold his bike(#807)sometime last year but he is still listed in the registry, he...
I barely know an amp from a volt and certainly don't know the perfect place to splice into but; If your Jenny uses auxiliary running lights mounted in front of...
One other thing I forgot--I upgraded from the 1157 to 2357 bulbs; they are about 20% brighter for only 0.5 amps more draw. You could do both your bike and the...
I understand the shunt type regulator systems the alinator is putting out full power all the time so there is no need to worry about current draw under...
No Jim, I haven't, at least not yet. I've been concentrating on the shunt regulators which I believe are overloading the stators. Yes, a beefier stator might...
Hi Roger, I don't mean to answer for Jumper, but: CPS is a crank position sensor. How are you comeing on the damaged brake line? Hope you have your bike up an...
I was cleaning my IACV last night while looking for any potential intake leak. I found the jug mounting screws for my X-man throttle back plate loose. I also...
The easiest way to test this is to give it the 90 degree twist test. Sit on the bike, or have someone of equivalent weight sit on it (you want to test with...
<I was cleaning my IACV last night while looking for any potential intake leak. I found the jug mounting screws for my X-man throttle back plate loose. I also...
That cap is the 49 state vacuum cap and was exactly the one that simply had a split; up the backside of course where I could not see it; drawing all sorts of...
#767 is wired for a trailer but it was that way when I bought it so I don't know the specifics. I believe Cappy put quite a few miles on with it. I glanced...
if I recall correctly, that's the barb that you connect that crankcase vent tbe to. If you have a remote vent, you cap the barb off. Please note: message...
I adjust mine as loose as i can get it without it rubbing on anything. That works aout to be about a 1-1/2" vertical travel. -bj Please note: message attached...
That's about where I set mine - one would feel it would skip and perhaps jump a tooth once in a while but it doesn't. ... From: <ivysimpson@...> To:...
Bill Marks (not related) in MN had a Jenny with a side car. I believe the work was done by John Jones. I don't know if Bill still is involved with the Xs',...
Belt = sloppy loose... 2 flats above jumping... 1 1/2 ought to do it.. depending on how heavy you/extras are.... Sit on it loaded and check. If it's tight and...
Those of you that were at Roast thought I was crazy for taking my X on my High Points Ride. 1043 ran great. The only problem I had was on the last day when the...
