Many of you have contributed to the X-Community in one way or another. What would Members think if we were to put together a list of those who have contributed...
What kinda power we talkin about here Stan? How's this translate to street bike tranny performance? Are we going to need aftermarket tranny doors like are...
I would also mention Stan's racing research; that could prove to be our most important benefit in the long run. -john #803 ... From: Excelsior-Henderson Super...
Its the halfway in part that isn't clear. Halfway to what? I pushed them onto the bolt such that the outer edge of the rejuvinator is flush with the end of...
A little bit further then flush, it should look like you could fit two in there. With the mount bolt centered, you could cram three in there, but don't go...
What all can trigger the check engine light? It comes on as soon as a turn the switch and stays on as it runs. The oil light does not come on. The check...
Stan, We are comparing our Super X's with drag bikes we work on and your information is very helpful. Let me know what you need done with these trannys. Call...
John, if you go to http://www.koolbiker.com/index6a.htm on our page you will see a "Sportster" tranny door, these doors aren't any stronger than our Super X's....
i am turning much more rpm(8,000) compared to stock(5500-6000)so it is also jerking on the primary drive very hard, the bearing is pushing forward and rear on...
because my tach needle was jumping all over the place, at first I suspected the alternator connection that I had to disconnect while pulling the tranny. I...
If whatever set it on is fixed - the check engine lamp will extinquish itself after sufficient riding cycles (mine lasted about 50 miles and several cool down...
Stan, what did you re-sleeve the jugs with? Also, how far in did you re-locate the crank pins? What kind of head work did you do? Lots of dyno work needed for...
Stan, did you solid mount the engine? Have you experienced any broken headpipes on X-bikes due to the frame mounted exhaust and rubber mounted engine? On my...
This motorcycle is purely X-Perimental, untill ANY of this shit is THOROUGHLY tested i cant in any way release any details or pics for fear of some moron...
My point is that the ECU is expensive and a relay is not. I would like to let the ECU (or the ECU onboard relay) power a relay and let the relay power the...
What might seem meaningless to some still annoys me. My front coil springs vibrate wildly when cold at certain RPM's. They actually hit the frame or horn...
Slash cuts!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! then no more rattle, seriously though check for proper tightness on all front end components ..... good luck. ...
Mine does that at road speed. The springs set up a harmonic with the wind. But I just don't let it bother me. Too many other things about the bike to be...
John, My springs vibrate wildly (I love it) - but I don't hear any rattling. There have been posts on this board some time ago about the chrome shock covers...
No; it's the springs rattling against the shock covers. I can reach up with my foot and stop the spring, eliminating the rattle, then it just starts ...
Delano's is no longer servicing the E-H, we are doing the hub updates with the steel bearing carrier and 2 bearings on the drive side. Are mods retain the...
i have found on several bikes the lower strut cover(1399-0029) will come loose i guess it is the only dam thing they didnt loc-tite, use Mac tools #71-045 soft...
I replaced my front mounts with newer stiffer ones and got rid of my spring rattle for now. I'm stillexperimenting with mount compounds. john #803 ... From:...
I had reinforced the bracket, lubricated the switch, and was not using the key. The locking cyclinder is still in the ignition switch on the bike, but the...
