Hi Dale- Datsun has a couple of different size input shafts, If you will measure the od on the shaft and count the number of splines, and give me a outside...
I am trying to find out the bolt spacing on a 312 13" wheel. I don't have the car yet. It is a 4 bolt pattern with 13" rims. Does anyone know the bolt pattern...
Wheel rotors are getting hot. Calipers don't appear to be getting stuck. On this model (RL411 SSS), are they supposed to normally be very hot? ..I figured...
Posted at dimequarterly.com: sss wagon -- have an early datsun sss wagon for sale .the car has been sitting for at least 10 year .it is complet except air...
***ATTENTION*** I'm presuming noone relized this thread is a QUESTION. I'm needing a little assistance. I feel as though I've been shunned at this site...
Call a brake shop to be sure, but IIRC disk brakes always drag a bit, that's a part of the design. There is no return spring to retract the pads like there...
I didn't think you were being shunned. Maybe sometimes no one has anything to say. I know Carl is swamped busy, and frankly so am i. anyway, dont give up Ian ...
Hi Brent, I doubt anyone is 'shunning' you. For myself, just REAAAAAAAALY busy and distracted. Little to no time for the lists. Hang in, I see Adam ...
One other thought. You might be constantly applying some pressure to the brakes. Did you replace the brake master cylinder? If so, did you replace with...
hey, come to think of it, according to the datsun service bulletin regarding the RL411 the brakes are desinged to have a small self energizing effect since by...
I want one! http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=37879&SortOrder=1 Edgar [Non-text portions of this message have been removed]...
well I'll be darned! there is a model of the 411!! http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=223&item=4212466464&rd=1 or item number 4212466464 ...
Well, that's the first of THAT kind I've seen. But seems pretty ballsy to want that kind of money for a squashed model. BTW, I have a kit model of the 411 I...
Thanks for the replies! .....I'm using the origonal brake cylinder. I haven't looked at the actual pedal adjustment/shim possibilities. I have lifted the...
ummmm, and how do you plan on sending an attachment here? Ian ... http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=223&item=4212466464&r ... ===== ".......
I don't know if they should get that hot even though discs are interface brakes(contact all the time)I think your rotors are warped or a(or 2) stuck caliper...
I'm not too familiar with Datsun calipers but my Chevy and Ford van & Bronco (respectively) do not get that hot. I would be afraid that kind of heat might do...
I'm not too familiar with Datsun calipers but my Chevy and Ford van & Bronco (respectively) do not get that hot. I would be afraid that kind of heat might do...
Greetings fellow club members, I must admit that I normally don't take part in the discusions in this forum because to tell the truth, I simply don't have the ...
I just paid 1,700.00 for a L320 truck in so so condition. Gas prices are going over 3.00 in Cal,happy to have a true high mileage vichle. No smog. Mikie...
Here's the story, I burned out on my 320 project. A young fellow came up to me all hot to finnish the truck, So I gave it to him. His wife says "No way, get...
